Always there to help you
Register your product and get support at
www.philips.com/welcome
Question?
Contact
Philips
User manual
AJ3700/12
Contents
1Important
3
2 Your clock radio
3
3
4
3 Get started
5
5
6
6
4 Listen to FM radio
6
6
6
5Alarm
7
7
7
7
6AJ3700_Others
8
8
8
7 Product information
8
8
8Troubleshooting
9
9Notice
9
9
What's in the box
Overview of the main unit
Install battery
Connect power
Set time
Tune to FM radio stations
Store and select preset radio station
Set the alarm time and mode
Deactivate the alarm
Set sleep timer
Use the projection
Adjust brightness
Specifications
Declaration of conformity
EN
2
1Important
Warning
•• Never remove the casing of this clock radio.
•• Never lubricate any part of this clock radio.
•• Never place this clock radio on other electrical
equipment.
•• Keep this clock radio away from direct sunlight, naked
flames or heat.
•• Make sure that you always have easy access to the
power cord, plug or adaptor to disconnect the clock
radio from the power.
•
•
•
•
•
•
3
Make sure that there is enough free space
around the product for ventilation.
The clock radio shall not be exposed to
dripping or splashing.
Do not place any sources of danger on the
clock radio (e.g. liquid filled objects, lighted
candles).
Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Only use power supplies listed in the user
manual.
Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
unit:
• Install all batteries correctly, + and - as
marked on the unit.
• Do not mix batteries (old and new or
carbon and alkaline, etc.).
• Remove batteries when the unit is not
used for a long time.
• The batteries should not be exposed
to excessive heat such as sunshine fire
or the like.
EN
2 Your clock radio
Congratulations on your purchase, and
welcome to Philips! To fully benefit from the
support that Philips offers, register your product
at www.philips.com/welcome.
What's in the box
Check and identify the contents of your
package:
• Main unit
• 1 x AC adaptor
• Short user manual
• Safety sheet
PR
OJ
EC
T IO
PR O
N
JE
CT
IO
N
O
c
N
FF
RE
E
e
SE
T
AL
AR
M
SE
1
P R E S E T 1- 5
1
TA
LA
2
RM
f
2
RS
/O
a
VE
Overview of the main unit
b
+
5
HO
3
g
TE +
i
C
UR
ON
d
TI
TA
PR OJ E
M IN U
RO
TE
h
4
S ET
T IM E
r
RADIO ON/OFF
j
s t
SLEEP
ALARM RESET
n
TUNING
AL
AL
u
S N O O Z E
BRIGHTNESS
ON
k
OFF
PRESET
1
PROJECTION CLOCK RADIO AJ3700
VOLUME
AL1
AL 2
DC 7.5V
l
o
m
p
a REVERSE PROJECTION
• Reverse the projection.
b Projection lens
c PROJECTION ON/OFF
• Switch the projection on/off.
d ROTATE PROJECTION
• Adjust projection slightly to a different
angle.
e SET ALARM 1 / PRESET 1
• Set ALARM1 timer.
q
• Program or select station 1.
f SET ALARM 2 / PRESET 2
• Set ALARM2 timer.
• Program or select station 2.
g MINUTE+ / PRESET 3
• Adjust the minute.
• Program or select station 3.
h SET TIME / PRESET 4
• Set the clock time.
• Program or select station 4.
i HOUR+ /PRESET 5
EN
4
• Adjust the hour.
• Program or select station 5.
j + TUNING • Tune to radio stations.
k - Volume +
• Adjust volume.
l DC-IN
• Power supply socket.
m FM ANT
• Improve FM reception.
3 Get started
Caution
•• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
n Display panel
• Show current information.
Install battery
o AL1/AL2
• View alarm settings.
• Activate or deactivate alarm timer.
Insert 4 x 1.5V R6/UM3/AA battery (not
supplied) with correct polarity (+/-) as
illustrated.
p RESET
• Reset the device.
q Battery compartment
r RADIO ON/OFF
• Switch the radio on/off.
s SLEEP
• Set the sleep timer.
t ALARM RESET
• Deactivate the alarm.
u SNOOZE/BRIGHTNESS
• Snooze alarm.
• Adjust display brightness.
4 x 1.5 V R6/UM3/AA
5
EN
Connect power
Caution
4 Listen to FM
radio
•• Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the clock radio.
•• Risk of electric shock! When you unplug the power
adapter, always pull the plug from the socket. Never
pull the cord.
Note
•• Keep the clock radio away from other electronic
devices to avoid radio interference.
•• For better reception, fully extend and adjust the
position of the FM antenna.
Note
•• The type plate is located at the bottom of the clock
radio.
Connect the AC power adaptor to :
• the power supply socket on the main unit.
• the wall power outlet.
Tune to FM radio stations
1
2
3
Set time
Note
•• You can only set time in standby mode.
1
2
3
4
Press RADIO ON/OFF to activate the
radio.
»» The last selected radio frequency
displayed on the panel.
Press and hold TUNING +/- for over 2
second.
»» The clock radio tunes to a station of
sufficient reception automatically.
Repeat step 2 to tune to more radio
stations.
To tune to a station manual :
• Press TUNING +/- repeatedly until you
find optimal reception.
Store and select preset radio
station
You can store up to 5 radio stations.
Press SET TIME to enter the clock setting
mode.
Press HOUR+ to adjust the hour.
1
2
Press MINUTE+toadjust the minute.
Press SET TIME to confirm.
3
Tune to a radio station.
Press the number button until you hear a
beep.
»» The preset number of station show on
the display.
Repeat step 1-2 to tune more stations.
• You can overwrite a preset station by
storing another frequency in its place.
Press the number button to select
corresponding preset radio station.
EN
6
5Alarm
Set the alarm time and mode
In standby mode, you can set two alarms to ring
at different time.
Note
•• Make sure that you have set the clock correctly.
1
2
3
4
Press and hold SET ALARM 1 or SET
ALARM 2 to activate alarm setting mode.
Press HOUR+ to adjust the hour.
Press MINUTE+ to adjust the minute.
Press SET ALARM 1 orSET ALARM 2 to
confirm.
Tip
•• To check the alarm time , press AL1 or AL2 button.
Deactivate the alarm
There are 3 ways to switch off the alarm.
24 hour alarm reset :
If you want to stop alarm immediately but
retain the same setting for the following days:
• PressALARM RESET/SLEEP.
»» The clock radio beeps once.
Repeat alarm :
• When alarm sounds, pressREPEAT
ALARM/BRIGHTNESS CONTROL.
»» The alarm snnozes and repeats ringing
nine minutes later. (maximum 6 times)
Cancle the alarm completely:
• Press AL1 or AL2 once or more until OFF
appears.
7
EN
Set sleep timer
The clock radio switched off automatically after
a preset period.
Press ALARM RESET/SLEEP repeatedly to
select sleep timer period.
»» SLEEP and SL:120 / SL:90 /SL: 60 /
SL:30 / SL: 15 will show on the display
panel respectively.
To deactivate the sleep timer :
Press ALARM RESET / SLEEP repeatedly until
OFF appears.
6AJ3700_Others
Use the projection
You can project the clock time onto a surface
with this device.
1
2
3
4
5
Press PROJECTION ON/OFF.
»» The projection lens lights up .
7Product
information
Note
•• Product information is subject to change without prior
notice.
Scroll the projection lens wheel to find a
suitable projection surface. (maximum 180
degree left or right )
Specifications
To reverse the projected time , press
REVERSE PROJECTION.
Amplifier
To change the projected angle. scroll the
ROTATE PROJECTION. (maximun 60
degree left or right)
Press PROJECTION ON/OFF to switch
off.
»» The Projection lens lights off.
Note
•• When battery-powered. the projection lens lights up
slightly to save energy.
•• For a long time projection , please use AC power to
operate.
Adjust brightness
Press REPEAT ALARM/BRIGHTNESS
CONTROL repeatedly to adjust display
brightness.
Rated Output Power
0.35W RMS
Tuner (FM)
Tuning range
Tuning grid
Sensitivity
- Mono, 26 dB S/N Ratio
Search Selectivity
Total Harmonic Distortion
Signal to Noise Ratio
87.5-108 MHz
50 KHz
<22 dBf
>28 dBf
<2%
>50 dBA
General information
Power supply
- AC power
- Battery
Operation Power
Consumption
Standby Power
Consumption
Dimensions:
Main Unit
(W x H x D)
Weight: -Main Unit
Model:
ASUC30E-075025;
Input: 100-240 V~,
50/60 Hz; 0.3 A;
Output:DC7.5V
250mV
6V, 4 x 1.5V R6/UM3
1.5 W
<1 W
88 x 107 x 118 mm
0.38 kg
EN
8
8Troubleshooting
Warning
•• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
•• Ensure that the AC power plug of the unit
is connected properly.
•• Ensure that there is power at the AC
outlet.
No sound
•• Adjust the volume.
No response from the unit
•• Disconnect and reconnect the AC power
plug, then turn on the unit again.
Poor radio reception
•• Increase the distance between the unit and
your TV or VCR.
•• Fully extend the FM antenna.
Alarm does not work
•• Set the clock/alarm correctly.
Clock/alarm setting erased
•• Power has been interrupted or the power
plug has been disconnected.
•• Reset the clock/alarm.
9
EN
9Notice
Any changes or modifications made to this
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Declaration of conformity
Hereby, WOOX Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
of Directive 1999/5/EC. You can find the
Declaration of Conformity on www.philips.com/
support.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
Your product contains batteries covered by
the European Directive 2006/66/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
EN
10
Specifications are subject to change without notice
2013 © WOOX Innovations Limited. All rights reserved.
This product was brought to the market by WOOX
Innovations Limited or one of its affiliates, further referred
to in this document as WOOX Innovations, and is the
manufacturer of the product. WOOX Innovations is the
warrantor in relation to the product with which this booklet
was packaged. Philips and the Philips Shield Emblem are
registered trademarks of Koninklijke Philips N.V.
AJ3700_12_UM_V1.0