Always there to help you
Register your product and get support at
www.philips.com/welcome
Question?
Contact
Philips
User manual
SBT300/12
Contents
1Important
3
Safety3
Notice3
2 Your Bluetooth Speaker
5
Introduction5
What's in the box
5
Overview of the main unit
5
3 Get started
6
6
6
4Play
7
7
8
8
5 Product information
9
9
6Troubleshooting
9
Connect power
Turn on
Play from a Bluetooth device
Play from an external device
Control play
Specifications
EN
2
1Important
Safety
•
•
Important Safety Instructions
•
•
•
•
•
•
•
•
•
•
•
•
3
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not use this device near water.
Clean only with dry cloth.
Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
Do not install near any heat sources such
as radiators, heat registers, stoves, or other
devices (including amplifiers) that produce
heat.
Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the device.
Only use attachments/accessories specified
by the manufacturer.
Unplug this device during lightning storms
or when unused for long periods of time.
Refer all servicing to qualified service
personnel. Servicing is required when the
device has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have
fallen into the device, the device has been
exposed to rain or moisture, does not
operate normally, or has been dropped.
Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
unit:
• Install all batteries correctly, + and - as
marked on the unit.
• Do not mix batteries (old and new or
carbon and alkaline, etc.).
EN
•
• Remove batteries when the unit is not
used for a long time.
• Batteries (battery pack or batteries
installed) shall not be exposed to
excessive heat such as sunshine, fire or
the like.
Devices shall not be exposed to dripping
or splashing.
Do not place any sources of danger on
the device (e.g. liquid filled objects, lighted
candles).
Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
•• Never remove the casing of this apparatus.
•• Never lubricate any part of this apparatus.
•• Never place this apparatus on other electrical
equipment.
Notice
Any changes or modifications made to this
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
0 Hereby, WOOX Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
of Directive 1999/5/EC. You can find the
Declaration of Conformity on www.philips.com/
support.
This product complies with the radio
interference requirements of the European
Community.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
The making of unauthorized copies of copyprotected material, including computer
programs, files, broadcasts and sound
recordings, may be an infringement of
copyrights and constitute a criminal offence.
This equipment should not be used for such
purposes.
Note
•• The type plate is located on the back of the apparatus.
Your product contains batteries covered by
the European Directive 2006/66/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
EN
4
2 Your Bluetooth
Speaker
Overview of the main unit
a
b
c
Congratulations on your purchase, and
welcome to Philips! To fully benefit from the
support that Philips offers, register your product
at www.philips.com/welcome.
f
d
e
Introduction
With this speaker, you can enjoy audio from the
compatible Bluetooth device or other audio
devices.
What's in the box
Check and identify the contents of your
package:
• Main unit
• 1x AC adaptor
• Short user manual
• Safety sheet
5
EN
a ON/OFF
• Turn on/off the unit.
b
c
/
• Adjust volume.
• Press to play/pause in Bluetooth mode.
d DC IN 5V-1A
• Power supply socket.
e AUDIO IN
• Connect an audio device.
f Bluetooth indicator
• Steadily on when the speaker is
connected with Bluetooth compatible
device.
• Flashes when disconnected Bluetooth
pairing .
3 Get started
Caution
•• Use of controls, adjustments, or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Connect power
This Bluetooth speaker can be powered by
either AC power or batteries.
AC power
Caution
•• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the speaker.
Connect the AC power adaptor to:
• the power supply socket on the back of
the speaker.
• the wall power outlet.
Battery power
Warning
DC IN
5V . 1A
•• Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
•• The battery contains chemical substances, so it should
be disposed of properly.
•• Keep children away from the battery.
1
2
3
Open the battery compartment.
Insert AA batteries with correct polarity
(+/-) as indicated.
Close the battery compartment.
Turn on
•
Switch ON/OFF on the speaker to the
ON positon.
»» The Bluetooth indicator flashes (blue).
EN
6
Switch to standby mode
The speaker switches to standby mode in the
following situations.
• In Bluetooth mode: deactivate bluetooth
connection without audio in cable plugged
in.
• In MP3 link mode: no audio signal
detected over 15 minutes.
• The battery level is low.
4Play
Play from a Bluetooth device
You can listen to a Buetooth device through this
speaker.
Note
•• The effective operation range between the speaker
and your Bluetooth device is approximately 10 meters
(30 feet).
1
2
Switch ON/OFF to turn on the speaker.
Press and hold
for 3 seconds to
activate Bluetooth function on the speaker.
»» The Bluetooth indicator flashes.
3
Activate the Bluetooth function in your
Bluetooth device (see the device user
manual).
4
Select "PHILIPS SBT300" on your device
for pairing.
»» The speaker gives out 2 beeps and the
Bluetooth indicator stays steadily on.
• For elder devices, you need to input
"0000" as pairing password.
5
Do
Start music play on your Bluetooth device .
Do
3 sec.
PHILIPS SBT300
7
EN
PIN
0000
Play from a PC
You can also listen to audio through Bluetooth
in PC.
Play from an external device
You can also listen to an external audio device
through this speaker.
Note
•• Make sure that you have installed Bluetooth driver in
your PC before pairing.
•• The steps below are only for windows 7 operating
system. If you use other OS/IOS , refer to other OS/
IOS help.
1
2
3
4
5
6
Note
•• Your speaker can play under MP3-LINK audio only
when the Bluetooth paused or stopped.
1
Switch ON/OFF to turn on the speaker.
Press and hold
for 3 seconds to
activate Bluetooth function on the speaker
»» The Bluetooth indicator flashes.
Activate the Bluetooth function in your PC.
2
Connect the MP3-LINK cable to:
• the MP3-LINK jack (3.5mm) on the
back of the speaker.
• the headphone jack on an external
device.
Start to play on the device.
Add a Bluetooth device in your PC and
select "PHILIPS SBT300" for pairing.
»» The speaker gives out 2 beeps and the
Bluetooth indicator steadily on.
Set "PHILIPS SBT300" as default
communication device in your PC.
1). Right click the speaker icon ( ) in
the lower right corner of the Windows
home screen and select "Playback Devices"
from the option menu
2). Right click desired speaker and select
"Set as Default communnication Device".
Start music play on your PC .
AUDIO IN
Control play
During play,
• press VOL +/- to increase or decrease the
volume level.
• press
to play or pause.
»» Available only in Bluetooth mode.
EN
8
5Product
information
•• Product information is subject to change without prior
notice.
Specifications
Amplifier
Rated Output Power
Signal to Noise Ratio
Aux-in Link
2 x 2 W RMS
>67 dB
600 mV RMS 20
kohm
PC-SBT300_Bluetooth
Range
V2.1 + EDR
2.402-2.480 GHzISM
Band
10 m (free space)
General information
AC power (power
adaptor)
Operation Power
Consumption
Dimensions - Main Unit
(W x H x D)
Weight- Main Unit
9
EN
Warning
•• Never remove the casing of this apparatus.
Note
Bluetooth version
Frequency band
6Troubleshooting
Model:
ASUC12E-050100
Input: 100-240V,
50/60Hz, 0.3A;
Output: 5V 1A;
4W
300 x 117 x
118mm
1.15 kg
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
•• Make sure that the AC power plug of the
speaker is connected properly.
•• Make sure that there is power at the AC
outlet.
•• Make sure that the batteries are inserted
correctly.
No sound
•• Adjust the volume.
No response from the speaker
•• Restart the speaker.
2014 © WOOX Innovations Limited.
All rights reserved.
Philips and the Philips’ Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used by WOOX
Innovations Limited under license from Koninklijke Philips N.V.
SBT300_12_UM_V2.0