Philips CD Soundmachine AZ105S

Always there to help you
Register your product and get support at
www.philips.com/welcome
Question?
Contact
Philips
User Manual
AZ105
Contents
1Important
3
2 Your CD Soundmachine
4
3 Get started
6
4Play
8
5 Product information
9
Introduction4
What's in the box
4
Overview of the main unit
5
Connect power
Turn on
Play disc
Listen to FM radio
Play from an external device
Specifications
Maintenance
6
7
8
8
8
9
9
6Troubleshooting
10
7Notice
10
EN
2
1Important
•
•
•
•
•
•
•
•
•
•
•
•
3
Read these instructions.
Follow all instructions.
Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the unit.
Only use attachments/accessories specified
by the manufacturer.
Unplug this unit during lightning storms or
when unused for long periods of time.
Refer all servicing to qualified service
personnel. Servicing is required when the
unit has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have
fallen into the apparatus, the unit has been
exposed to rain or moisture, does not
operate normally, or has been dropped.
Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
unit:
• Install all batteries correctly, + and - as
marked on the unit.
• Do not mix batteries (old and new or
carbon and alkaline, etc.).
• Remove batteries when the unit is not
used for a long time.
Batteries (battery pack or batteries
installed) shall not be exposed to excessive
heat such as sunshine, fire or the like.
The unit shall not be exposed to dripping
or splashing.
Do not place any sources of danger on
the unit (e.g. liquid filled objects, lighted
candles).
EN
•
Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
•• Never remove the casing of this apparatus.
•• Never place this apparatus on other electrical
equipment.
•• Never look into the laser beam inside this apparatus.
Caution
•• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
2 Your CD
Soundmachine
Introduction
With this CD Soundmachine, you can:
• listen to FM radio;
• enjoy audio from discs, and other external
audio devices;
• program the play sequence of tracks.
The unit offers you Dynamic Bass Boost (DBB)
to enrich sound.
What's in the box
Check and identify the contents of the package:
• Main unit
• AC power cord
• Short user manual
EN
4
Overview of the main unit
a
b
k
c
j
d
i
e
f
h
g
l
p
m
n
o
a - VOLUME +
• Adjust volume.
b SHUFFLE
• In CD mode, play tracks randomly.
c REPEAT
• In CD mode, play a track or all tracks
repeatedly.
d
e
5
• Start or pause play.
• Stop play.
• Erase a program.
EN
f Display panel
g PROG
• In CD mode, program the play
sequence of tracks.
h FM frequency indicator
i LIFT TO OPEN
• Open or close the disc compartment.
j - TUNING +
• Tune to FM radio stations.
k
/
• Skip to the previous or next track.
• Search within a track.
l FM antenna
• Improve FM reception.
m Source selector
• Select a source: FM, Audio-in, or CD.
• Turn the unit off.
n Audio-in
• Connect an external audio device.
o AC~ MAINS
• Connect power.
p DBB switch
• ON/OFF: turn dynamic bass boost on
or off.
3 Get started
Caution
•• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Connect power
The unit can be powered by either AC power
or batteries.
Option 1: AC power
Warning
•• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the unit.
•• Risk of electric shock! When you disconnect the AC
power, always pull the plug from the socket. Never pull
the cord.
Connect the AC power cord to:
• the AC~ MAINS socket on the unit.
• the wall socket.
Note
•• To switch the unit off completely, disconnect the power
cord from the power supply socket.
EN
6
Turn on
Switch the source selector to FM, Audio-in, or
CD.
AC~MAINS
Turn off
Switch the source selector to OFF.
Option 2: Battery power
Caution
•• Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•• Batteries contain chemical substances, so they should
be disposed of properly.
Note
•• Batteries are not supplied with the accessories.
1
2
3
7
Open the battery compartment.
Insert 6 batteries (type: R14/ UM2/ C
CELL) with correct polarity (+/-) as
indicated.
Close the battery compartment.
EN
Switch to standby mode
In CD mode, the unit switches to standby
mode after 15 minutes of inactivity.
To exit the standby mode:
• Press
; or
• Select an audio source.
4Play
4
5
Repeat step 3 to program more tracks.
Press
to play the programmed tracks.
»» During play, [PROG] (program) and
the preset number are displayed.
• To erase the program, press
Play disc
1
2
3
Switch the source selector to CD.
Control play
/
Select an audio file;
Press and hold to fast-forward
or fast-reverse the track during
playback, then release to resume
play.
Pause or resume play.
Stop play.
REPEAT
[ ]: Play the current track
repeatedly.
[
]: Play all tracks repeatedly.
]: Play tracks randomly.
SHUFFLE
[
- VOLUME + Adjust volume.
Enhance bass
To turn dynamic bass boost on or off, slide DBB
switch to ON or OFF.
Program tracks
You can program a maximum of 20 tracks.
1
2
3
Listen to FM radio
Lift to open the disc compartment.
Insert a disc with the printed side facing up,
then close the disc compartment.
»» Play starts automatically.
Press
twice.
Note
•• Position the antenna as far as possible from TV, VCR or
other radiation source.
•• For optimal reception, fully extend and adjust the
position of the antenna.
1
2
Switch the source selector to FM.
Rotate - TUNING + to tune to an FM
radio station.
Play from an external device
You can also listen to an external audio device
through this unit.
1
2
3
Switch the source selector to Audio-in.
Connect an audio cable (3.5mm, not
supplied) to:
• the Audio-in socket on the unit.
• the headphone socket on an external
device.
Play the external device (see the device's
user manual).
Note
•• The Audio-in socket is not for headphones.
to stop playback.
Press PROG to activate the program
mode.
»» [PROG] (program) begin to blink.
Press
/
to select a track number,
and then press PROG to confirm.
EN
8
5Product
information
Note
•• Product information is subject to change without prior
notice.
General
Power supply
- AC Power
220-240 V ~, 50/60 Hz
- Battery
9 V, 6 x 1.5 V R14/UM2
Operation Power
Consumption
15 W
Standby Power
Consumption
< 0.5 W
Dimensions - Main Unit
(W x H x D)
261 x 123 x 245 mm
Weight - Main Unit
1.1 kg
Specifications
Maintenance
Amplifier
Rated Output Power
Frequency Response
Signal to Noise Ratio
Total Harmonic
Distortion
Audio-in Input
2 x 1 W RMS
63 -14000 Hz, -3 dB
>57 dBA
<1 %
650 mV RMS
Disc
Laser Type
Disc Diameter
Support Disc
Total Harmonic
Distortion
Frequency Response
Signal to Noise Ratio
<1%
63 -14000 Hz, -3 dB
>57 dBA
Tuning Range
FM: 87.5 - 108MHz
Total Harmonic Distortion <3 %
Signal to Noise Ratio
>50 dBA
Speakers
9
EN
Clean discs
• When a disc becomes dirty, clean it with
a cleaning cloth. Wipe the disc from the
centre out.
Semiconductor
12cm/8cm
CD-DA, CD-R, CD-RW
Tuner
Speaker Impedance
Clean the cabinet
• Use a soft cloth slightly moistened with
a mild detergent solution. Do not use a
solution containing alcohol, spirits, ammonia
or abrasives.
8 ohm
•
Do not use solvents such as benzene,
thinner, commercially available cleaners,
or antistatic spray intended for analogue
records.
Clean the disc lens
• After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure good
play quality, clean the disc lens with Philips
CD lens cleaner or any commercially
available cleaner. Follow the instructions
supplied with cleaner.
6Troubleshooting
Warning
•• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
•• Ensure that the AC power plug of the unit
is connected properly.
•• Ensure that there is power at the AC
outlet.
•• Insert the batteries with their polarities
(+/– signs) aligned as indicated.
•• Replace the battery.
No sound
•• Adjust the volume.
No response from the unit
•• Take out the batteries and turn on the unit
again.
•• Disconnect and reconnect the AC power
plug, then turn on the unit again.
No disc detected
•• Insert a disc.
•• Check if the disc is inserted upside down.
•• Wait until the moisture condensation at
the lens has cleared.
•• Replace or clean the disc.
•• Use a finalized CD or correct format disc.
Poor radio reception
•• Increase the distance between the unit and
your TV or VCR.
•• Fully extend the FM antenna.
7Notice
Any changes or modifications made to this
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
This product complies with the radio
interference requirements of the European
Community.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
Your product contains batteries covered by
the European Directive 2006/66/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
EN
10
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
paper pulp (buffer) and polyethylene (bags,
protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
This apparatus includes these labels:
Class II equipment symbol
This symbol indicates that the apparatus has a
double insulation system.
Note
•• The type plate is located on the bottom of the
apparatus.
11
EN
Specifications are subject to change without notice
© 2013 Koninklijke Philips Electronics N.V.
All rights reserved.
AZ105_79_UM_V1.0