Philips 4000 series 22PFK4209/12 22" Full HD Black LED TV

ontinuously ries o mprove ts
products and we recommend that you update
the TV software when updates are available.
What you need
To update with a USB storage device, you
need:
• An empty USB flash drive. The USB flash
drive must be FAT or DOS-formatted.
Do not use a USB hard drive.
• A computer with Internet access
• An archive utility that supports the ZIP
file format (for example, WinZip® for
Microsoft® Windows® or Stufflt® for
Macintosh®).
Step 1: Check the current software
version
1
2
3
4
5
Press
.
1
2
3
4
5
6
7
From your PC, navigate to www.philips.
com/support.
Find your product and locate the
software and drivers available for your TV
set.
» The software is available as a zip file.
If the software version is higher than the
version on your TV, click the software
update link.
Accept the license agreement and save
the ZIP file to the USB flash drive.
Using the archive utility, extract ‘autorun.
upg’ to the root directory of the USB
flash drive.
Disconnect the USB flash drive from the
PC.
Step 3: Update the TV software
Warning
• Do not switch off the TV or remove the USB flash
drive during the software update.
• If a power failure occurs during the update, do not
Select [Setup] > [Software settings] >
[Current software info], then press OK.
» The current software information is
displayed.
•
Write down the software version
number.
1
To return, press OK.
2
To exit, press
Insert the USB flash drive into a USB port
on your PC.
.
Step 2: Download the latest software
Caution
• Do not install a lower version of software than the
current version installed on your product. Philips
cannot be held liable or be made responsible for
problems caused by a software downgrade.
3
remove the USB flash drive from the TV. The TV will
continue the update as soon as power is restored.
If an error occurs during the update, retry the
procedure. If the error reoccurs, contact Philips
Consumer Care.
Switch off the TV and disconnect all USB
storage devices.
Connect the USB flash drive (containing
the software update) to the USB
connector on the TV.
Switch on the TV.
» The TV detects the USB flash drive
and starts to scan for software
version.
» A message prompts you to update
the software.
EN
1
Eng lis h
Update the TV
software
Note
• IftheUSBflashdriveisnotdetected,disconnectit
andreconnectagain.
4
5
6
Followtheon-screeninstructionsto
updatetheTVsoftware.
Oncecomplete,disconnecttheUSBflash
drivefromtheTV.
Select[Restart],thenpressOKto
restarttheTV.
Note
• TopreventaccidentalupdatestotheTVsoftware,
deletethe‘autorun.upg’filefromtheUSBflashdrive.
2 EN