Marmitek IR Eye 2 Specification

Add to my manuals
2 Pages

advertisement

Marmitek IR Eye 2 Specification | Manualzz
DECLARATION OF CONFORMITY
Hereby, Marmitek BV, declares that this IR EYE 2 is in compliance with the essential requirements and other
relevant provisions of the following Directives:
DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004 on the
approximation of the laws of the Member States relating to electromagnetic compatibility
Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the
laws of Member States relating toelectrical equipment designed for use within certain voltage limits
Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of
certain hazardous substances in electrical and electronic equipment
IR EYE 2™
Universal IR Extender Cable
Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes IR EYE 2 den grundlegenden Anforderungen
und den anderen relevanten Festlegungen der Richtliniën:
RICHTLINIE 2004/108/EG DES EUROPÄISCHEN PARLAMENTS UND DES RATES vom 15. Dezember 2004 zur Angleichung
der Rechtsvorschriften der Mitgliedstaaten über die elektromagnetische Verträglichkeit
Richtlinie 2006/95/EG des Europäischen Parlaments und des Rates vom 12. Dezember 2006 zur Angleichung der
Rechtsvorschriften der Mitgliedstaaten betreffend elektrische Betriebsmittel zur Verwendung innerhalb bestimmter
Spannungsgrenzen
Richtlinie 2002/95/EG des Europäischen Parlaments und des Rates vom 27. Januar 2003 zur Beschränkung der
Verwendung bestimmter gefährlicher Stoffe in Elektro- und Elektronikgeräten
Par la présente Marmitek BV déclare que l'appareil IR EYE 2 est conforme aux exigences essentielles et aux
autres dispositions pertinentes de la directives:
DIRECTIVE 2004/108/CE DU PARLEMENT EUROPÉEN ET DU CONSEIL du 15 décembre 2004 relative au rapprochement
des législations des États membres concernant la compatibilité électromagnétique
Directive 2006/95/CE du Parlement européen et du Conseil du 12 décembre 2006 concernant le rapprochement des
législations des États membres relatives au matériel électrique destiné à être employé dans certaines limites de tension
Directive 2002/95/CE du Parlement européen et du Conseil du 27 janvier 2003 relative à la limitation de l'utilisation de
certaines substances dangereuses dans les équipements électriques et électroniques
Marmitek BV declara que este IR EYE 2 cumple con las exigencias esenciales y con las demás reglas relevantes
de la directriz:
DIRECTIVA 2004/108/CE DEL PARLAMENTO EUROPEO Y DEL CONSEJO de 15 de diciembre de 2004 relativa a la
aproximación de las legislaciones de los Estados miembros en materia de compatibilidad electromagnética
Directiva 2006/95/CE del Parlamento Europeo y del Consejo de 12 de diciembre de 2006 relativa a la aproximación de las
legislaciones de los Estados miembros sobre el material eléctrico destinado a utilizarse con determinados límites de tensión
Directiva 2002/95/CE del Parlamento Europeo y del Consejo de 27 de enero de 2003 sobre restricciones a la utilización de
determinadas sustancias peligrosas en aparatos eléctricos y electrónicos
Con ciò, Marmitek BV, dichiara che il IR EYE 2 è conforme ai requisiti essenziali ed alter disposizioni relative
alla Direttiva:
DIRETTIVA 2004/108/CE DEL PARLAMENTO EUROPEO E DEL CONSIGLIO del 15 dicembre 2004 concernente il
ravvicinamento delle legislazioni degli Stati membri relative alla compatibilità elettromagnetica
Direttiva 2006/95/CE del Parlamento europeo e del Consiglio del 12 dicembre 2006 concernente il ravvicinamento delle
legislazioni degli Stati membri relative al materiale elettrico destinato ad essere adoperato entro taluni limiti di tensione
Direttiva 2002/95/CE del Parlamento europeo e del Consiglio del 27 gennaio 2003 sulla restrizione dell'uso di determinate
sostanze pericolose nelle apparecchiature elettriche ed elettroniche
Bij deze verklaart Marmitek BV, dat deze IR EYE 2 voldoet aan de essentiële eisen en aan de overige relevante
bepalingen van Richtlijnen:
RICHTLIJN 2004/108/EG VAN HET EUROPEES PARLEMENT EN DE RAAD van 15 december 2004 betreffende de
onderlinge aanpassing van de wetgevingen van de lidstaten inzake elektromagnetische compatibiliteit
Richtlijn 2006/95/EG van het Europees Parlement en de Raad van 12 december 2006 betreffende de onderlinge
aanpassing van de wettelijke voorschriften der lidstaten inzake elektrisch materiaal bestemd voor gebruik binnen
bepaalde spanningsgrenzen
Richtlijn 2002/95/EG van het Europees Parlement en de Raad van 27 januari 2003 betreffende beperking van het gebruik
van bepaalde gevaarlijke stoffen in elektrische en elektronische apparatuur
MARMITEK BV - P.O. BOX 4257 - 5604 EG EINDHOVEN – NETHERLANDS
20580 / 20130606 • IR EYE 2
ALL RIGHTS RESERVED MARMITEK ©
Technical Specifications
Installation EN
The infrared LEDs have a self-adhesive tape on the back. Use this to stick
them onto the IR sensor of your A/V equipment. This should be done
precisely. Test the position of the IR LEDs first.
ATTENTION: If you are only connecting one A/V device, then you don't need
to use the second IR LED. Never remove this LED from the wire!
Installation DE
Die Infrarot-LEDs sind mit einer selbstklebenden Folie versehen. Somit
können Sie die beiden IR LEDs auf dem Infrarotsensor Ihrer Geräte
befestigen. Achtung, das erfordert große Genauigkeit. Testen Sie erst die
Position der IR LEDs bevor Sie diese auf das Sensor kleben.
ACHTUNG: Wenn Sie nur ein Gerät bedienen wollen, lassen Sie den zweiten
IR Sender dann ungenutzt. Entfernen Sie diesen niemals vom Kabel!
Installation FR
Les LED infrarouges sont équipées d’un film auto-adhésif. Cela vous permet
de coller les deux LED IR sur le capteur IR de votre équipement A/V. Attention
: faites en sorte qu’ils soient positionnés de façon très précise.) Testez au
préalable la position des LED IR avant de les coller sur le capteur IR.
ATTENTION: Lorsque vous n’utilisez qu’un seul appareil, l’autre LED IR reste
hors d’usage. N’enlevez jamais cet LED IR du câble!
IR Sensor
Copyrights
Marmitek is a trademark of Marmidenko BV | IR EYE 2™ is a trademark of Marmitek BV. All
rights reserved.
Copyright and all other proprietary rights in the content (including but not limited to model
numbers, software, audio, video, text and photographs) rests with Marmitek B.V. Any use of the
Content, but without limitation, distribution, reproduction, modification, display or transmission
without the prior written consent of Marmitek is strictly prohibited. All copyright and other
proprietary notices shall be retained on all reproductions.
Instalación ES
Los LED infrarrojos están provistos de una lámina autoadhesiva. Con esta
puede fijar los pequeños transmisores en el sensor infrarrojo de sus aparatos.
Ha de posicionarlos con mucha precisión. Compruebe la posición de los LED
IR antes de pegarlos en el sensor infrarrojo.
ATENCIÓN: Si utiliza solamente un aparato, deje el segundo transmisor
infrarrojo fijado al cable. ¡Nunca lo quite del cable!
Installazione IT
I LED a infrarossi sono provvisti di una pellicola autoadesiva. In questo modo
potete fissare entrambi i trasmettitori sul sensore IR dell’impianto. Attenzione:
quest’operazione richiede precisione. Controllate la posizione dei LED IR
prima di attaccarli sul sensore.
ATTENZIONE: Se si utilizza solo un singolo apparecchio, non occorre usare il
secondo trasmettitore IR. Non staccarlo mai dal cavo!
Installatie NL
De infrarood LED’s zijn voorzien van een zelfklevende folie. Hierdoor kunt u
de IR LED's op de IR vensters van uw A/V apparaten bevestigen. Let op, dit
komt nauwkeurig. Test eerst de positie van de IR LED’s voordat u ze vastplakt
op het IR venster.
LET OP: Gebruikt u maar één A/V apparaat, dan laat u de tweede IR LED
ongebruikt. Verwijder deze nooit van de kabel!
IR extender cable with 2 blinking LEDs
Connection:
3.5mm jack plug (mono)
IR LEDs:
2x IR LED (blink when transmitting IR signals)
Length of cable:
3 meters (plug to divison 2m, divison to LED 1m)
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging
must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed
of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and
electronic equipment via designated collection facilities appointed by the government or local authorities. Correct
disposal and recycling will help prevent potential negative consequences to the environment and human health. For more
detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or
the shop where you purchased the product.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement