Datasheet

Crimping Tool Professional

Crimping 8P8C/RJ45 - 6P6C/RJ12 - 6P4C/RJ11 - 4P4C/4P2C

1a 1b 2

3

6

4

7

Package Contents

Q

Q

1x Crimping Tool Professional

1x Screw Driver

5

8

Instructions

To open the handles squeeze handles until it stops.

1a Insert the 4P or 6P cable from the two-bladed side of the stripper until it touches the stop guide

(stripping length 6mm).

1b Insert the 8P cable between the two stripper blades and let it extend a little over the lower cut blade.

2 Squeeze handles until stop, keep the cable perpendicular and then pull from the tool.

3 Insert round cables into the round stripping hole, squeeze handles until stop, turn the tool in counter clockwise direction and the cable in clockwise direction simultaneously, pull from the tool.

4 Insert the stripped cable into the plug and make sure that the left wire at one end matches the right wire at the other end.

5 Place the modular plug with cable into the tool's holder.

Be sure the stripped wire is between the tab and the gold contacts. Squeeze the handles until stop.

6 Remove the crimped plug from the tool.

7 To release the ratchet turn the screw on the ratchet in counterclockwise direction.

8 To crimp DEC plugs remove the screw on the left side of the 6P holder, insert the DEC plug with cable into the 6P holder and squeeze handles until stop.

www.equip-info.net