Converting Windows to Android Installation Steps for I800QW

Converting Windows to Android Installation Steps for I800QW Things you will need for this process: 




1 Keyboard 1 Mouse 1 Hub 1 Flashdrive (must be formatted to FAT32, USB must be 3.0 &16GB) A USB to USB‐Micro cable 1.) Extract the files from the RAR. Once extracted, open the “Drivers” folder and install the provided drivers onto your PC. 2.) Flash Drive MUST be formatted to FAT32 and named “WINPE”. Copy all contents of the “BIOS fromWIN8changeToANDROID” folder into the flash drive. It should look like this: 3.) Connect Keyboard, Mouse, Hub and Flashdrive. 4.) Once everything is connected, Power on the tablet while pressing F7 on the keyboard. 5.) A Blue Screen will Pop Up that states “Please Select Boot Device”, select “UEFI: Built‐in EFI Shell” and press Enter. 6.) At the shell, press Enter to go into the command prompt. 7.) At the command prompt, type “fs1:” and press enter. 8.) The shell will then say “fs1:\> ___” Type in “f” in the blank space, so it should say “fs1:\> f” then press Enter. The tablet will then reinstall the BIOS. 9.) When you see the green text “FPT Operation Passed” you’ll be prompted again, type “Exit” to exit the shell. Then turn off the tablet and disconnect it from the hub. 10.) Open the folder “FirmwareW816‐T_4.4.4_20141222” on your PC. You should see the following files: 11.) Open the file called “TurnOffInstall”. You should see the following screen: 12.) Press and hold all 3 buttons on the tablet as you connect the tablet to the PC. Once the installation begins, let go of the tablet buttons. The program will then install the Android Firmware. The process should take several minutes. 13.) When the program says “Press any key to continue,” disconnect the tablet from the PC. Tablet is now ready to use.