Mini Bluetooth Network Receiver Manual

Introduction
Mini IP68 Bluetooth Network
Mini IP68 Bluetooth Network LED Receivers pair with the
Mini Bluetooth Netwok LED Controller and drive the LEDs.
These Bluetooth Network LED Receivers work with constant
voltage LEDs from 6-24VDC.
LED Receivers
Dimmer / WA / RGB / RGBW
There are four models to cover just about any kind of LED
application: dim-mini-BTnetwork-receiver for single color
applications, wa-mini-BTnetwork-receiver for white
adjustable, rgb-mini-BTnetwork-receiver for RGB and rgbwmini-BTnetwork-receiver for RGBW.
User Manual
1
3
2
Full Circuit Protection
Single Color to RGBW
IP68 Waterproof
Wireless Sychronizing
Ultra-Slim Design
High Power Output
Simple Setup
3
dim-
Installation
rgb-
rgbw-
C). RGB: The black cable connects to LED load positive.
Red, green and blue cables connect to the respective LED
color.
1. Power Supply
Mini IP68 Bluetooth Network LED Receivers work from
6-24VDC. The red power input cable should be connected
to power supply positive and black to negative. The
receiver output voltage is same as the power supply
voltage. Always make sure the power supply voltage is
same as the rated LED voltage.
2. Status Indicator
The status indicator displays the current status of the receiver.
Blue: normal operation.
Short single white flash: command signal received.
White flash 3 times: Paring success.
Red flashing: overload protection active.
Yellow flashing: thermal protection active.
3. LED Output
These receivers support constant voltage LED products
and control the load using a PWM output. The output
cable color indicates the function, described below.
A). Single color: The red cable connects to LED
positive and black to negative.
wa-
2
B). White Adjustable: The black cables connect to LED load
positive, the yellow cable connects to warm white negative
and the white cable connects to cool white negative
D). RGBW: The black cable connects to LED load positive.
The white, red, green and blue cables connect to the
respective LED color.
Pairing
4. Pairing
Mini Bluetooth Network Receivers must be paired to a
controller to operate. To pair Network LED Receivers to
a mini-BTnetwork controller, perform the following
steps with the mini-BTnetwork powered on.
1. Power-off the receiver for at least 5 seconds and
power it back up.
2. Press the on/off key and down arrow on the miniBTnetwork remote within 5 seconds of the receiver
powering on.
3. The indicator on the receiver will flash 3 times to
confirm the pairing.
Specifications
Advanced Features
5. Waterproofing
Mini IP68 Bluetooth Network LED Receivers are IP68
waterproof. When installing at wet environment, the cable
connections must also be waterproofed. Waterproofing
glue and heat-shrink are recommended, but waterproof
connectors may also be used. Wireless signals are
attenuated by water, so wireless range may be reduced if
the receivers are installed underwater. Be sure to test the
wireless range before permanently installing the receiver
in water or very wet locations.
Model
dim-mini
wa-mini
Function
Single Color
White
Adjustable
15A
2x7A
Working voltage
Rated output current
Synchronization
frequency
Wireless receiver
sensitivity
Overload protection
rgb-mini rgbw-mini
RGB
RGBW
6-24VDC
3x5A
4A+3x2.5A
2.4GHz ISM band
<-85dBm
Yes
Thermal protection
Yes
IP grade
IP68
Power-off memory
Yes
6. Protection
Mini IP68 Bluetooth Network LED Receivers have full
protection circuitry for short circuit, output overload,
reversed power polarity and overheating. The indicator will
flash red for overload or short circuit protection and flash
yellow for thermal protection. The receiver will
automatically recover from protection when conditions
return to normal.
5