H3-EM Electronic Locking Swinghandle

H3-EM Electronic Locking Swinghandle
iClass**
Reader
RFID card reader option · Latch status indicator
Single or multi-point latching
38
Connection Diagram
• Remote lock and unlock
• Momentary or continuous
lock actuation
• Local monitoring with
multi-color LED indicator
• Lock status outputs for
remote monitoring
• Industry standard
25x150mm panel prep kits for other panel preps
available
• Integral key lock for manual
over-ride
• Options for combined
electronic lock and
RFID card reader
• Reader recognizes existing employee 125kHz or 13.56 MHz RFID cards
24V
PIN 3: DATAO or TX (green wire)
PIN 4: DATA1 or no connect (white wire)
ACTUAL SIZE
PIN 2
PIN 4
4 PIN - See Connection Diagram
PIN 1
Electromechanical
lock connector
Lock control harness
(order separately)
PIN 8
PIN 1: GND2
PIN 2: VSUPPLY1
RJ45 - See www.southco.com
for PIN output details
PIN 5: Electronic Lock Signal
PIN 6: Mechanical Lock Status
PIN 2
PIN 4
PIN 6
(1) VCC and VSUPPLY may be connected together
(2) EML and Card reader must use a common GND
PACS for MIFARE Classic 4k SE only
‡ ** M
IFARE, MIFARE Classic,
MIFARE Plus and MIFARE DESFire
are trademarks of NXP B.V.
Electromechanical lock connector
Part Number
Latch Output
Termination
For R=
EA-W01-500
From Swinghandle
to Stripped and Tinned End
All
EA-W23-503
From Wiegand or RS232 Output Card Reader
to Stripped and Tinned End
6, 7, 8, 9
EA-W23-503-83
From Wiegand Output Card Reader
to EA-P1-01X (Pin/Prox Controller)
6, 7, 8, 9
EA-W01-23-507
From Swinghandle and Card Reader
to Stripped and Tinned End
6, 7, 8, 9
EA-W01-23-507-03
From Swinghandle and Card Reader
to Hirose 8-Pin Connector
6, 7, 8, 9
EA-W01-52-506-52-A
From Swinghandle and Card Reader
to RJ45 Connector
4, 5
EA-W01-52-506-A
From Swinghandle and Card Reader
to Stripped and Tinned End
4, 5
Part Number Selection
H3 - EM - 6 R - LLL - 10
***
***Remove ‘-10’ for latch without Southco Logo
LLL
000
001
003
Lock style
No lock or keys
Blank lockplug:
Bright Chrome
Blank lockplug:
Black powder coat
100
200
300
R Compatible Card Type Default †**
4
MIFARE® Classic 4k MIFARE Plus ® 2k
‡
‡
UID / PACS
MIFARE® DESFire® 4k
HID® iCLASS
UID
UID
PACS
UID
UID
PACS
UID
5
UID /PACS
6
UID
UID
UID
7
UID
UID
UID
HID® 125kHz Prox
8
CSN
CSN
9
EM 125kHz Prox
CSN
Wiegand
www.southco.com/H3-EM
RS232
4 PIN
RJ45
✔
✔
✔
✔
✔
✔
✔
✔
✔
CSN
Other options available. For complete details
on variety, part numbers, installation and
specification, go to
Reader
Connector
✔
Without Card Reader
0
High security DIN lock
Key code CH751
Key code RS001 (Multiple RS key codes available)
Output
PACS = Physical Access Control System UID = Unique Identifier CSN = Card Serial Number
R
PIN 1
PIN 3
PIN 5
5 Meter* Wire Harnesses (order separately) *Contact Southco for other lengths
See specific latch trade drawings
for compatible card types
** H ID iCLASS is a registered
trademark of HID Global.
PIN 3
PIN 4: Lock Control Signal
Notes
†
PIN 1
PIN 1: GND2 (black wire)
PIN 2: VCC1 (red wire)
ACCESS CONTROL UNIT
12V
See Reader Connector options in table
Card reader harness
with connector
Four PIN connector only
Now Available
Card Part Numbers
EA-C1-011-9 (EM 125 kHz Prox card, 26 bit, 1.8 (0.07) thick)
EA-C2-021-9 (HID® 125kHz card, 26bit, 1.8 (0.07) thick)**
EA-C3-101-9 (MIFARE® Classic 1k card, 4B CSN, 0.8 (0.03) thick)**
Dimensions in millimeters (inch) unless otherwise stated
✔
✔
39
Swinghandle with Card Reader
29
(1.14)
Grip
44
(1.75)
52
(2.0)
24.5
(.96)
Material & Finish
Swinghandle
without Card Reader
Glass-filled nylon, PC/ABS
(UL94-V0)
Dual Frequency
Card Reader
Shaft, rotation limiter: Die-cast zinc,
bright sealer
12V
ACTUAL SIZE
Electronic Swinghandle
24V
Card Reader
+0.3
-0
+.012
-0
25
(.984
Frame
Cam
Length "L"
(see table
below)
20 (.8)
Cam
213
(8.4)
150 +0.3
-0
(5.906 +.012
)
-0
Status
indicator
LED
168
(6.6)
Door
thickness
30±4
(1.18±.16)
or
37±4
(1.46±.16)
Short
cam
1 Select required Electronic
Swinghandle part number using
selection guide.
Long
cam
2 Select cam part number using
cam part number table.
Cam Part Number (Order seperately)
Grip
Rotation limiter
Edge DistanceTop
See Note 2
Cam
mounting
bracket
Frame edge
Cam bolt
M6 thread
Bottom
mounting bracket
Actuator Plate
Cam
5x Mounting
Screws
Optional
gearbox
25.75
accessory
(1.01)
Short Cam
38 (1.5)
Long Cam
45 (1.77)
15.5 (.61)
E5-6710
17.5 (.69)
E5-6711
Grip range
19.5
(.77)
E5-6712
E5-6112
(17.5 (0.69)
Example using
21.5 (.85)
E5-6713
E5-6113
offset cam)
23.5 (.93)
E5-6714
E5-6114
Other additional offsets:
(1) See Southco Drawings J-E5-67-A & J-E5-67-B
(2) See Southco Drawings J-E5-61-A & J-E5-61-B
Rod System Part Numbers (order seperately)†
24.50
(.96)
Card Reader Module
To Order:
37
(1.46)
Rod Systems
Typical operating current:
Less than 200mA at 12VDC
Peak / stall operating current: 1 Amp
Standby current: 50mA Max
Output Signal: 100mA Max load
Supply voltage: 12VDC to 24VDC
Operating current: 200mA Max
DIN profile
lock plug
25.8
(1.01)
)
Recommended operating voltage:
12VDC to 24VDC
H3-61-55-33
Left Hand Gearbox
(CCW to open)
H3-61-56-33
Right Hand Gearbox
(CW to open)
A5-90-105-11
Actuator Plate
3 For multi-point applications,
select optional gear box / rod
adaptors or actuator plate.
4 Select optional wire harness.
5 Order cards as needed.
For standalone systems order
Southco EA-P1-010 controller.
Contact Southco for details on
ordering networked systems.
DOOR OPEN
LAN
CONTROLLER
† For multi-point systems, select either the right or left hand
gear box part number and rod adaptor (2 per door) part
numbers or the actuator plate part number from table, then
visit www.southco.com/A5 for rod selection.
Other options available. For complete details
on variety, part numbers, installation and
specification, go to
Dimensions in millimeters (inch) unless otherwise stated
www.southco.com/H3-EM