CM812 remote control wireless mixer _work in progress

CM812(rf) remote control wireless mixer
Control your sound system from anywhere in the
building!
•
•
Ideal for use within churches, schools and
colleges
Gives you freedom to do your job without
having to be a sound engineer
Main Control Unit
•
•
•
•
•
•
•
•
•
Industry standard 19” 1U painted metal casework
Remote to main connection by VHF wireless transmission (up to 100m line of sight transmission)
8 input channels : inputs can be mic/line or CD level
2 output channels
Each input can be assigned to either or both output channels
Balanced mic inputs connected via 2-part terminal block
Phantom power available on mic inputs
Line and CD inputs connected via twin phono sockets
Separate sensitivity preset per line input channel to enable balancing of different input levels
Remote Control Unit
•
•
•
•
•
Uncomplicated, easy to use control panel
Separate illuminated ON/OFF switches
and level controls for each channel
2-band EQ on each input channel
(adjustable from remote control unit)
3 Preset complete configurations which
can be set or recalled from the remote
control unit
Remote control unit batteries can power
unit for minimum of 15 hours between
charges. Recharge time less than 8
hours
Rear panel view
Main control unit RF antenna
Wireless mixer remote control unit
Specifications
•
•
•
•
•
•
Inputs , Mic : 3.5mV balanced into 600 ohms (2-part terminal block)
Line : 1V unbalanced into 10K ohms (stereo phono) CD/High level line
275mV unbalanced into 10K ohms (stereo phono) Low level line
Outputs : 775mV , 560 ohm unbalanced (1/4” stereo jack)
Noise : Mic inputs -60.5dB (10 – 100k Hz) , Line inputs -76.0dB (10 – 100k Hz)
Power : 240v ac 50/60 Hz 15VA max using IEC connector
Remote power : 3 x C type rechargeable
Mechanical : Main unit , 1U 19” rack casing 170mm deep
Other models
CM812 – Wired version available – Remote control unit connects with a CAT5 cable up to 200m to main
control unit.
Available from