Radio tuner - HomeSystems Legrand

TECHNICAL SHEET
Radio tuner
035 82
Description
Power supply from SCS BUS:
Max. absorption:
Absorption in stand-by:
Dissipated power:
Operating temperature:
FM reception band:
18 – 27 Vdc
20 mA @27 V – 25 mA @18 V
5 mA @27 V – 9 mA @18 V
0.5 W
5 - 45 °C
87.5 – 108 MHz
Antenna to be connected
Maximum level (*):
Minimum level (*):
70 dBμV
40 dBμV (mono) - 50 dBμV (stereo)
(*) The maximum and minimum levels that must be guaranteed at the antenna socket for
correct FM band reception.
Dimensional data
4 DIN modules
Configuration
S MEM ANT
S:
1 – 4 local address of the source
MEM: number of stations that can be stored
Configurator
No. of stations
–
5
2
10
3
15
ANT: this indicates the type of antenna used by the radio
Configurator
Type of antenna
–
Indoor(wire)
1
Outdoor(Coax)
2
8
3
4
7
6
5
Legend
1. Wire antenna
2. MCX connector for the outdoor antenna (e.g. roof antenna) (*)
3. Green LED on steady: good quality signal reception
4. Red LED on steady: stereo reception (mono reception when off)
5. Configurator socket
6. Removable 2 pole connector for the connection to the BUS SCS of the Sound system
7. Radio tuner programming and radio program scanning keys
Frequency decrease
Frequency increase
Selection/storage of stations (short/extended pressure)
Frequency scanning mode: manual/automatic
Press at the same time for 5 seconds to store the station in the memory
8. LED backlit display for the display of frequency, RDS messages, and stored stations
(*) Cable with MCX-F connector supplied as standard.
1
LG00214-a-UK
Technical data
1
SCS BUS SYSTEM
The radio tuners item 035 82 can receive FM radio stations. The front pushbuttons and
the backlit display adjust the device locally, save 15 radio stations and display RDS
messages and the tuned frequency.
It is also capable of performing two types of station searches: manual and automatic.
The device can be managed (switching ON and OFF, frequency change, etc.) both
locally and remotely (via the SCS BUS) using the flush mounted amplifier, or the MY
HOME control devices (e.g. Touch Screen and Local Display).
In order to receive the radio channels correctly the type of antenna used must be
selected: if the 035 82 is installed in a zone of the building with sufficient signal
strength, the wire antenna can be used. If the signal strength inside the building is
not sufficient, the external antenna can be used (e.g. antenna installed on the roof),
using the coaxial connector and the appropriate adapter cable. The type of antenna is
selected using the configurator.