FIG. 1
FAC-SIMILE LABELLING
LABELLING
OK
NO
USE AND CARE BOOKLET
CYCLING HELMET
FIG. 2
PRODUCT OF ITALY
FIG. 3
FIG. 4
WARNING
ACTIVITIES INVOLVING THE USE OF THIS EOUIPMENT
FOR YOUR OWN ACTION AND DECISIONS.
BEFORE USING THIS EOUIPMENT. YOU MUST:
- READ AND UNDERSTAND ALL INSTRUCTIONS FOR USE.
- GET SPECIFICTRAINING IN ITS PROPER USE.
- BECOME ACQUAINTED WITH ITS CAPABILITIES AND LIMITATIONS
- UNDERSTAND AND ACCEPTTHE RISKS INVOLVED
FAILURE HEED ANY OF THESE WARNINGS
MAY RESULT IN SEVERE INJURY OR DEATH
KASK S.p.A.
24060 Chiuduno, BG
Via Firenze, 5 - Italy
t. +39 035 4427497
info@kask.it
www.kask.com
AS/NZS 2063
COD:420162 - ED. 09/2016
DIAGRAM LABELLING
WARNING
Athletic activities involving the use of this equipment are inherently dangerous. You are responsible
for your own decisions and actions. Before using this equipment, you must: - Read and understand
the attached user instructions in their entirety. - Receive relevant training involving the use of
the equipment. - Become acquainted with the capabilities and limitations of the equipment. Understand and accept the risks involved.
FAILURE TO HEED THE ABOVE WARNINGS MAY RESULT IN SERIOUS INJURY OR DEATH.
ATTENTION TO PARENTS This helmet should not be used by children for any activity. DO NOT
ALLOW YOUR CHILDREN TO USE THIS HELMET OR PLAY WITH IT. Doing so can put your
children at risk of serious injury or death.
PLEASE READ CAREFULLY
WARNING: This helmet is intended for use in athletic activities that are extremely dangerous.
FAILURE TO HEED THESE WARNINGS OR FOLLOW THESE INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY OR DEATH.
WARNING: Please read carefully and understand the following instructions. Use this helmet for the
activities for which it is certified (see Labelling), and those activities only.
WARNING: Improper use of this helmet may cause serious or fatal injury. If the instructions are
not followed correctly, the level of protection offered by the helmet can be significantly reduced.
Before each use, please carefully inspect the helmet for any signs of visible damage.
DO NOT USE THE HELMET IF THERE IS ANY SUSPICION OF ITS CONDITION, ESPECIALLY
AFTER A MAJOR IMPACT.
WARNING: It is mandatory that the user is fully aware of all the features of the helmet, its
capabilities and limitations, and receives specific instructions and/or training in the proper use of
the helmet from a competent and responsible professional.
WARNING: USERS OF THE HELMET ARE FULLY RESPONSIBLE FOR THEIR ACTIONS AND
ASSUME ALL RISKS FOR THEIR DECISIONS.
KASK S.p.A., its affiliates, subsidiaries, importers, distributors and dealers will accept no
responsibility in the event of any accident leading to injury or even death and will not be liable for
any injury, death, loss, or damage resulting from improper use of this helmet.
WARNINGS
(a) No helmet can protect the wearer against all possible impacts.
(b) The helmet is designed to be retained by a strap under the lower jaw.
(c) To be effective, a helmet must fit and be worn correctly. To check for correct fit, place helmet on
head and make any adjustment indicated. Securely fasten retention system. Grasp the helmet and
try to rotate it to the front and rear. A correctly fitted helmet should be comfortable and should not
move forward to obscure vision or rearward to expose the forehead.
(d) No attachments should be made to the helmet except those recommended by the helmet
manufacturer.
(e) The helmet is designed to absorb shock by partial destruction of the shell and liner. This damage
may not be visible. Therefore, if subjected to a severe blow, the helmet should be destroyed and
replaced even if it appears undamaged.
(f) The helmet may be damaged and rendered ineffective by petroleum and petroleum products,
cleaning agents, paints, adhesives and the like, without the damage being visible to the user.
(g) A helmet has a limited lifespan of use and should be replaced when it shows obvious signs of
wear.
(h) This helmet should not be used by children while climbing or doing other activities where there
is a risk of hanging or strangulation if the child gets trapped whilst wearing the helmet.
CERTIFICATIONS
This KASK helmet complies with the AS/NZS 2063:2008 safety standard for bicycle helmets.
WARNINGS
WARNING: This helmet cannot always protect the user from injury. No helmet can protect the
head from a blow generated by violent impact. Following major impact, even in the case of no
visible damage, the helmet should be immediately replaced.
WARNING: Certain chemical products, especially solvents, can damage your helmet. Protect your
helmet from exposure to chemicals.
WARNING: Paint and stickers may contain materials that can alter the physical properties of
the helmet over time. Before applying any of these products, verify their compatibility with the
manufacturer.
WARNING: The helmet can be damaged from improper care: do not sit on the helmet, pack it
too tightly, drop it, allow it to come into contact with sharp or pointed objects, etc. Do not expose
your helmet to high temperatures, such as leaving the helmet inside a vehicle in direct sunlight.
SAFETY
For your maximum safety and protection:
ALWAYS
- Always wear a helmet whenever and wherever you ride, even on a short ride. Accidents can occur
anywhere, and at any time.
- Always ride responsibly. Your safety is your own responsibility. Observe and follow all traffic laws and regulations.
- Always wear a helmet of appropriate size and brightly coloured clothing.
- Always wear a helmet low in the front to protect your forehead.
- Always check the adjustments every time you wear your helmet, tighten the chin strap and securely fasten the buckle.
- Always inspect your helmet and its straps regularly for signs of wear or damage. Replace your helmet immediately if it shows any visible signs of wear or damage.
- Always replace your helmet after an accident, even if there is no visible damage.
- Always watch carefully for parked cars and drivers turning in front of you. Drivers often do not see
the bicycle or the rider. - Always wear a helmet designed specifically for cycling activities.
NEVER
- Never take unnecessary risks just because you are wearing a helmet.
- Never wear your helmet with the buckle unfastened.
- Never wear anything under your helmet except for a winter cap accessory specifically designed for your helmet and supplied by your helmet manufacturer.
- Never assume that vehicle drivers can see you. Drivers often do not see the bicycle or the rider.
- Never ride at night without proper lighting or reflectors.
- Never wear this helmet while riding a motorcycle or other motorised vehicles.
- Never wear a helmet that has been in an accident, even if no damage is visible.
- Never wear someone else’s helmet.
INSTRUCTIONS
As a protective measure, this helmet must be worn at all times during athletic activity. For
adequate protection, it is important that the helmet be sized correctly and fit the head properly
to offer optimum comfort and safety. The helmet should be adjusted to fit the user; for example,
the straps should be positioned so that they do not cover the ears, the buckle should be kept away
from the jawbone, and the straps and buckle should both be adjusted so that they are comfortable
and secure. After properly buckling and adjusting the strap, always check that the helmet is not
excessively tight; nor should it move freely back and forth (see Fig. 1).
HELMET ADJUSTMENT
Put on the helmet by rotating the rear dial (clockwise to tighten and counter-clockwise to enlarge)
until you obtain the desired fit (Fig. 2). Position the size adjustment system in the zone of the nape
(Fig. 3), regulating it in height. Close the strap by inserting one side of the buckle into the other,
(Fig. 4). Tug to check that the buckle is secure. Adjust the length of the neck strap to fit the helmet
securely to your head. The rubber ring should be placed at the end of the strap to keep it from
dangling. To remove the helmet, open the neck strap by pushing both side buttons on the snap
buckle at the same time (Fig. 4).
WARNING! DO NOT use the helmet if you cannot adjust it to achieve the correct fit in accordance
with these instructions or the helmet does not feel comfortable and stable while riding. Contact
your dealer or call the manufacturer directly for assistance.
REPLACEMENT PARTS
If necessary, contact the dealer or the manufacturer directly. None of the original components of
the helmet may be changed and/or removed without the manufacturer’s approval. The helmet
should not be modified to attach any accessories except for those supplied by the manufacturer.
ACCESSORIES
Check with the dealer or manufacturer whether accessories are available. If they are supplied
with the helmet, follow the mounting instructions that come with the accessory. Only accessories
approved by the manufacturer should be used.
CLEANING
Only clean the helmet with water, neutral pH soap, and a soft, clean cloth, allowing it to air dry at
room temperature. The inner lining should be washed by hand in cold water. If it is removable, it
can be removed and washed by hand in cold water or in the washing machine (max. 30°C/85°F). In
no case should chemical detergents or solvents be used. Petroleum-based solvents are especially
dangerous. They can damage a helmet so that its protective qualities are significantly impaired.
STORAGE
When not in use, the helmet should be stored away from direct sunlight and sources of heat, and
we recommend putting it back in the original package. Do not leave your helmet in your car or
anywhere else near direct or indirect heat. Do not apply adhesives, solvents, stickers, or paint that
do not comply with the manufacturer’s specifications. Any alteration or intervention not provided
for may impair its protective function.
TRANSPORT
Given the type of device (helmet), no particular instructions are necessary for its transport.
WARNING! DO NOT use the helmet if it has been exposed to high temperatures and/or damaged
by heat.
LIFETIME & INSPECTION
The helmet’s lifetime depends on a variety of factors which cause its deterioration, including
sudden temperature changes, degree of exposure to sunlight, and the intensity of use. Inspect the
helmet regularly to check for any damage! Cracks, detached parts, warping, flaking, and changes
in colour are significant elements for verifying the helmet’s state of deterioration. In any case, we
advise replacing it after approximately three (3) years from the original date of purchase, as over
time its capacity for protection decreases due to aging of the materials. Inspect helmet periodically
for damage and/or deterioration. If you find any cuts, abrasions, or other visible damage, contact
the manufacturer to have the helmet inspected before further use.
LIMITED WARRANTY
KASK helmets are warranted against defects in materials and/or workmanship for a period of two
(2) years from date of purchase. KASK will replace or repair any KASK helmet found to be defective
during the warranty period solely based on assessment with proof of purchase. This warranty is
applicable to purchases made in Australia and New Zealand from an authorised KASK distributor,
dealer and/or retailer. You must establish proof of purchase in order to obtain the warranty service
or replacement. Helmets purchased through unauthorised retailers are NOT covered under this
warranty. Only authentic KASK products are warranted. This warranty does not cover any product
damage resulting from accidents and/or negligence, product misuse, abuse, neglect, alteration,
improper care and incorrect use. KASK is not responsible for direct, indirect or accidental
consequences, or any other type of damage befalling or resulting from the use of its products. This
warranty does not cover any representation or warranty made by dealers beyond the provisions
of this warranty. This warranty gives you specific legal rights, in addition to other rights, which vary
from state to state.
LABELLING
Information contained on the inside of the helmet, printed on the label, should not be removed.
Download PDF
Similar pages
BradW
CVWL DV88
T'nB SPACHELM
oym5zi489y
Lenco ACC-A
Rollei Helmet & Surf Mount
Installation Guide - RE Full Face Helmet Kit
No Brainer
2.499 kr - Stenmarks Maskin
Conceptronic CACTIONCAMHM