- Computers & electronics
- Computer components
- Chassis components
- Racks
- Rack accessories
- CURT
- 18065
- Installation manual
CURT 18065 Bike Rack Installation manual
Add to my manuals2 Pages
CURT 18065 is a hitch-mounted premium bike rack designed to transport up to four bikes safely and securely. It fits into a 2" receiver tube and features adjustable arm straps to accommodate various bike sizes. This bike rack is not intended for off-road use or tandems/recumbents. Ensure the tightness of all bolts periodically and replace worn straps for safety.
advertisement
INSTALLATION INSTRUCTIONS
WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY
HITCH-MOUNTED PREMIUM BIKE RACK
WARNINGS
The tow vehicle must be equipped with a trailer hitch with 2" receiver tube opening.
Check straps for wear, and replace if worn.
This product is not intended for off-road use, tandems or recumbents.
Do not install on a trailer or other towed vehicle.
Check tightness of all bolts periodically.
PARTS LIST
6
7
8
4
5
2
3
Item#
1
Qty Description
1 Arm post
1
1
1
1
1
1
15
Shank, 2"
Arm straps, rubber
Bolt kit, hex head (bolt, two washers, nut)
Anti-rattle bolt and clip
Clip
Allen wrench, 8mm
Wrench, 19mm
1
2
8
4
5
6
7
3
PAGE 1 • 18065-INS-RB • 1.800.798.0813 • NEED ASSISTANCE?
• CURTMFG.COM
ASSEMBLY
Step 1
Raise the arms on the arm post (#1) to the outright position and secure with the attached lynch pin. See figure 1-A.
Step 2
Using the hex head bolt kit (#4), attach the bottom of the arm post (#1) to the shank (#2). Make sure to install the bolt in the bottom hole. See figure 1-B. Insert the bolt that is connected to the main body through the top hole of the shank and secure with the provided clip (#6). See figure 1-C.
INSTALLATION
Step 1
Insert the bike rack shank into the vehicle receiver tube.
Secure with 1/2" hex head bolt, flat washer, star washer and clip (#5).
A
Step 2
Install the bikes on the rack and secure with the provided rubber bike arm straps (#3). Be sure to secure the cross post and seat post to the rack. Note: When towing more than one bike, be sure to alternate the directions the bikes are facing on the rack. First bike faces right, 2nd bike faces left and so on. See the figure below.
Figure 1-A
B
Figure 1
C
Figure 1-B
FOLDING FEATURES
At the base, remove the clip from the upper bolt holding the bike rack in the vertical position. Remove the bolt and tilt the rack away from the vehicle. The rear cargo area is now accessible.
At the top, pull the lynch pin that secures the arms in the outward position. Fold the bike rack arms down to the transport position, and replace the lynch pin.
Figure 1-C
CURTMFG.COM •
NEED ASSISTANCE? • 1.800.798.0813 • 18065-INS-RB • PAGE 2
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project