TS1-PK – USB to Serial Converter Cable Installation

Copyright © BEP Marine Limited, All rights reserved
TS1-PK – USB to Serial Converter Cable
Installation
For Windows XP and Windows Vista follow Section 1
For Windows 7 follow Section 2
Section 1: Windows XP and Windows Vista
Step 1: Plug the USB to Serial Converter cable to your computer’s USB port.
For Windows XP and Vista, the following dialog window may pop up.
Select the ‘Yes, this time only’ option and then click the ‘Next’ button
to continue. Please note that if you plug the cable into a different USB
port next time, you may need to go through Step 1 to Step 4 again.
Also note that an internet connection is required and Windows
update must be enabled.
INST-USB2SER-V2
27/11/2007
Copyright © BEP Marine Limited, All rights reserved
Step 2: [Win XP and Vista] The following dialog window will pop up, which
shows that the USB to Serial Converter cable has been identified as
‘FT232R USB UART. Select the ‘Install the software automatically
[Recommended]’ option and then click the ‘Next’ button to continue.
INST-USB2SER-V2
27/11/2007
Copyright © BEP Marine Limited, All rights reserved
Step 3: [Win XP and Vista] Windows will take a few minutes to look online
for the driver required. This may take long depending on your internet
connection.
Step 4: The following dialog window will pop up, which indicates that the
USB to Serial Converter cable has been successfully installed on your
computer!, continue to step 5 if drive does not installed
INST-USB2SER-V2
27/11/2007
Copyright © BEP Marine Limited, All rights reserved
Step 5: If the USB Serial Converter does not install correctly, then unplug the
USB to Serial convertor cable and download the driver from the
following website (note, a internet connection is also required for
this step).
http://www.ftdichip.com/Drivers/CDM/CDM20802_Setup.exe
The following dialog window should pop up, Click Run.
Step 6: The following dialog window will appear, click Run
INST-USB2SER-V2
27/11/2007
Copyright © BEP Marine Limited, All rights reserved
Step 7: The following dialog window will pop up, which will install the driver
automatically.
Step 8:
Once the installer has finished, the above dialog should disappear,
Plug in the USB to Serial cable and the below window should appear,
Click “No, not this time” and follow Step 2 highlighted earlier.
INST-USB2SER-V2
27/11/2007
Copyright © BEP Marine Limited, All rights reserved
Section 2: Windows 7
Step 1: Download the USB to Serial converter driver found at this website,
http://www.ftdichip.com/Drivers/CDM/CDM20802_Setup.exe
The following dialog window should appear, Click Run.
Step 2: The following dialog window should appear when the driver has
finished downloading, Click Run.
INST-USB2SER-V2
27/11/2007
Copyright © BEP Marine Limited, All rights reserved
Step 3: The following window will appear, which will install the driver for the
USB to Serial convertor cable, the window will disappear when
installation is complete.
Step 4: Plug in the USB to Serial converter cable, and wait a few moments
while windows configures the driver, when windows has finished, the
following pop up should appear on the right hand corner of the screen
indicating the driver is installed and ready to use.
The latest documentation and software can be found on our website at:
www.bepmarine.com
INST-USB2SER-V2
27/11/2007