Model : ALB-4401R Single Channel Active Video Receiver

www.buildingsecurity.com.sg
Model : ALB-4401R
Single Channel Active
Video Receiver
Features
•
Full-motion color video signal up to 3936ft(1200m) via UTP cat5e/6
•
NTSC, PAL & SECAM video format compatible
•
Real-time transmission
•
12V/24V DC/AC power supply
•
Adjustable for various video distance
•
Integrated 2 channel video distribution amplifier allows dual output
•
Female BNC connector
•
Pluggable screw terminal block or UTP
•
Exceptional interference rejection
•
70 dB crosstalk and noise immunity
•
Full ground-loop immunity.
•
Built in TVS (Transient Voltage Suppressors) for surge protection
•
Lightning protection design Grade:V
•
Compact size and easy installation
•
Silver galvanized housing
Introduction
The ALB-4401R video balun is an active (amplified) device that allows the transmission
of real-time CCTV video signal via cost-effective Unshielded Twisted Paired (UTP) cable.
1
www.buildingsecurity.com.sg
Baseband (composite) signals of any type are supported.
The ALB-4401R is a compact unit. The power requirement is 12V/24V DC/AC. The
pluggable screw terminal block of ALB-4401R allows easy connection of UTP cable input.
It receives one single channel video signal from camera end via one UTP cable at
distance up to 3936ft (1200m) when used with active video transmitter. The transmission
distance reaches up to 2296ft (700m) when used with passive video transmitter. Its
integrated 2 channel video distribution amplifier allows dual output to display video at
both monitor and DVR.
The ALB-4401R has a single distance adjustment as well as built-in surge suppressor to
protect video equipment against damaging voltage spikes. Its Integrated Ground Loop
isolation prevents annoying "hum-bars" common with long distance installations and its
excellent crosstalk and noise immunity provides quality video up to the maximum
distance. The superior interference rejection and low emissions of the ALB-4401R allow
video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage
power circuits. This allows the use of a shared or existing cable plant.
Applications
•
Security Monitoring System
•
Multimedia Network Teaching System
•
Medical Monitoring Display System
•
Industrial Automation Control System
•
Banking, securities, financial information display system
2
www.buildingsecurity.com.sg
•
Remote Network Server Monitoring
•
Department Store Security
•
Casino Security
•
Hospitals, Airports and banks
•
School Campuses
Wire and Cable Recommendations
ALB-4401R is recommended to use with Unshielded Twisted Paired (UTP) wiring from
24AWG through 22AWG..Individually shielded pairs should be avoided, as they reduce
the operating range of the systems drastically. Multi-pair cable (25-pair or more) with an
overall shield are acceptable. Video signals can coexist in the same wire bundle as
telephone, datacom, or low-voltages power circuits. While video may be routed through
telephone punch-down block terminals, any bridge-taps, also called T-taps and any
resistive, capacitive or inductive devices MUST BE removed from the pair.
For more specific information regarding wire types, gauges and proper installation
techniques, please contact us for technical assistance.
3
www.buildingsecurity.com.sg
Specification

Product Name

Single Channel Active Video Receiver
CCTV cameras, monitors, DVR, switchers,
Applied Devices
IP encoders, and other CCTV equipment
Video

Video Format

Operating Frequency

PAL, NTSC, SECAM
Signal Band: 250MHz(-3db)
 Balance Band: DC to 6MHz
UTP Category 5e (24AWG) Color: 3936ft(1200m)
Max Distance

B&W: 6560ft(2000m)
Common-mode /
Differential-mode rejection


Attenuation

Impedance

75 dB
1.5 dB Max
Coax, female BNC 75Ω unbalanced
UTP, screw terminal block or RJ45 100Ω balanced

Video Distance Adjustment
4-position dip switches
LED Indicators

Red

Yellow
Power-On
“Active” signal present
Wire Type

One Unshielded Twisted Pair (for each video signal)
Network Wiring
24-16 AWG (0.5-1.31mm)

Category Type

Impedance
DC Loop Resistance
Differential Capacitance

2 or better
100 ± 20 ohms
52 ohms per 1,000ft (18 ohms per 100m)

19 pF/ft max (62 pF/m max)
4
www.buildingsecurity.com.sg
Power

Adaptive Voltage Arrange

AC/DC 9V-24V
12DVC Power Supply is recommended

Power consumption
<100mW
Connector

Video Input

Video Output
Female BNC Connector
Pluggable screw terminal block for UTP
Protection
Surge Protection
Ground Isolation

renewable solid state surge protection

Ground connection available for STP

Video Output

10/700us IEC6100-4-5/1955(GB/T 1726, 5-1999)
 2KV(different mode),

Video Input

Video Input Protection for
Over Current
or Ground loop removal
2KV(common mode),
4KV(common mode),
10/700us IEC6100-4-5/1955(GB/T 1726, 5-1999)

Protection for over 100mA current Max
Mechanical

Housing

Body Color

Dimensions (L*W*H)
Galvanized
Silver
85 * 64 * 22 mm
(BNC connector & mounting bracket excluded)

Net Weight
160g
Environmental

Operating Temperature
Relative Humidity
Storage Temperature

-20º~ 70 ºC
0~95% (non-condensing)

-40º~ 150 ºC
5
www.buildingsecurity.com.sg
Application Diagram
Ordering Information
• ALB-4401R Single Channel Active Video Receiver
For Sales Enquiries:
sales.sg@alstron.com.sg
6