Coaxial Cable Stripper Instructions

Coaxial Cable Stripper Instructions
STEP 1: SET THE ORANGE V-BLOCK TO THE PROPER WIRE SIZE BY
REMOVING IT, AND RE-INSTALLING IT WITH THE CORRECT SIZE.
STEP 4: REMOVE THE CABLE FROM THE STRIPPER. BLADE
DEPTHS CAN BE ADJUSTED WITH THE ALLEN SCREWS ON THE
BOTTOM OF THE UNIT.
STEP 2: INSTALL THE CABLE SO THAT IT IS FLUSH WITH THE
ORANGE WIRE INSERT.
STEP 5: IT IS RECOMMENDED YOU PULL OFF THE COAXIAL CABLE
REMNANTS WITH YOUR FINGERS TO EXTEND THE LIFE OF YOUR
STRIPPER BLADES.
STEP 3: SPIN THE STRIPPER THREE TIMES CLOCKWISE AND THEN
THREE TIMES COUNTER-CLOCKWISE.
STEP 6: FOLD BACK THE BRAID SO THAT YOUR CABLE LOOKS LIKE
THE ONE PICTURED ABOVE. YOU ARE NOW READY TO INSTALL
YOUR CONNECTOR.