RF-2800 Universal Video Modulator

VR 1 L
Universal Video Modulator
Channel Selectable
You can insert your favorite video program, such as DVD,
Satellite Receiver, Digital Set Top Box etc. to a TV without RCA connector through this
VR 1 L Video  RF Modulator and you can also share to several TVs in your home
through your RF distribution network.
Please read this manual carefully before using this unit and we recommend you to keep
this for further reference
Feature






SCART Input/output and 1 RCA input
Antenna input
Antenna output (TV)
DC power supply input
ON/OFF switch
Channel Adjustment (Up/Down key)
 LED Channel Number display
Top View
DVD
SCART Cable
SCART Cable
VCR
Satellite receiver
Input side
Set Top Box
Output side
Connection
1. Connecting RCA Video /Audio cable to (2), Please check the color-coded connection,
Yellow for Video, Red for Audio Right, White for Audio Left as labeled (2),
if you use SCART connector, please connect to SCART input as labeled (1)
2. Connect your CATV or TV cable (from Antenna) to (4)
3. Connect your TV set to (5)
1
4. Hook on the DC power (please note ,
it is very important to use the same rating
of DC Power adaptor as included,
wrong rating or input voltage will
cause unit to be destroyed ,
fire or even serious injuring)
5. if you want to connect the loop
through SCART Video, you can connect
SCART cable from the SCART out(3)
Of VR 1 L to your device.
To TV
Cable/Antenna Input
Power
Input
RCA Input
Operation
1. When you connection was ready, Please switch the slide switch on the front panel to
power on the unit.
2. Channel Setting: you can select the output channel by the CH +/- down to select the
channel that you want (from CH2 to CH4,S1 to S11, CH21 to CH69 ), there are two 7
segment LEDs on the top panel will show the channel been selected.
3. Please choose the un-used channel for you operation. If you did not use the un-used
channel, you will experience the distorted image and noisy sound.
The Channel comparison list is as below:
Channel
CH2~CH4
LED Display
-2~-4
S1~S11
1~11
CH21~CH69
21~69
Specifications:
RF:
Input
Input Connector
Output (RF-3200)
Output(combined)
Output connector
Video & Audio
Input
Output
Video Input impedance
Video S/N
Audio Input impedance
Powering
45~862MHz
IEC Female,75 Ohm
CH2-CH4,S1-S11,CH 21-69
45~862MHz
IEC Male,75 Ohm
RCA/SCART
SCART (Loop Through)
75ohm
40dB min
10K Ohm
9V DC
Accessories:
AC Adaptor x 1
RF Cable
230VAC (9V DC @ 200mA)
Male Female IEC @1M
Warning:
Keep the unit away form heat.
Indoor use only, in a dry and clean environment
Do not use the unit in humid room.
Do not open the unit.
Repairs should only be carried out by a qualified technician
2