Connect Laptop Here The Switcher Projector ON/OFF Select Input Using the projector VGA Cable 1. Press the “ON” button on the Switcher. 2. Press the “INPUT SELECTION” button that corresponds with the video device (RACK PC, Laserdisc, DVD, VCR or Laptop) that you want to use. 3. When you are finished press the “OFF” button on the Switcher. Connecting your laptop 1. Turn on the projector. 2. Plug the VGA cable (located in one of the drawers) into the Switcher as shown above. 3. Press the button labeled “LAPTOP” on the Switcher. 4. If an internet connection is required plug the network cable into the jack labeled “Laptop” (located on the wall underneath the chalkboard) and the other end into your laptop’s network port OR use the wireless network. The Audio Panel Audio System ON/OFF Audio Volume Connect audio device here. Using the audio system 1. Press the GREEN “ON” button on the audio panel. 2. Adjust the volume using the volume knob. 3. When you are finished press the RED “OFF” button to turn the audio system off. The Computer CD/DVD Computer ON/OFF USB Floppy Computer RESET Using the computer 1. Turn on the projector and the audio system. 2. Turn on the computer using the “ON/OFF” button. 3. Press the button labeled “Rack PC” on the Switcher. 4. The keyboard, mouse and wireless pointer will be in one of the drawers in the cabinet. Make sure to check both drawers. 5. When you are finished turn off the computer. Showing a video tape 1. Turn on the audio system and then the projector. 2. Turn on the VCR. 3. Press the button labeled “VCR” on the Switcher. 4. Insert your Tape and press play. Press here to open DVD tray Showing a DVD 1. Turn on the audio system and then the projector. 2. Turn on the Pioneer DVD/LD player. 3. Press the button labeled Power “DVD” on the Switcher. ON/OFF 4. Insert your DVD by pressing the DVD button on the right side of the player. 5. There is a remote control in one of the drawers for additional DVD control and functions. Please turn off the AV equipment when your class is over.