mi.1 manual - Quicco Sound

Usage Precautions
Do not leave this product in the following places:
Ÿ Places where there is direct sunlight, or inside automobiles in the sun.
Places with high heat such as near heaters.
Ÿ Places with high humidity or where condensation occurs.
This product does not have a waterproof construction. Use and store in
places where it will not be exposed to water or other liquids.
Ÿ Insert only into MIDI connectors.
Ÿ Follow local regulations and ordinances when disposing of this
product.
How to connect to iPhone/iPad
Installation
Check that the power of the electronic musical instrument
has been turned off.
Insert mi.1 into the MIDI IN/OUT ports as shown.
Connection between mi.1 and the iOS is made by Bluetooth Low
Energy MIDI. The connection is managed in the “Bluetooth Midi
Devices” List which the Piano Jukebox or some other MIDI apps
have.
1. Turn on the device to which the mi.1 is connected
2. Launch the Piano Jukebox app
For European Union
Information for Users on Collection and Disposal of
Old Equipment
This symbol on the products, packaging, and/or accompanying
documents means that used electrical and electronic products
should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take
them to applicable collection points, in accordance with your national
legislation and the Directives 2002/96/EC.
By disposing of these products correctly, you will help to save valuable
resources and prevent any potential negative effects on human health
and the environment which could otherwise arise from inappropriate
waste handling.
For more information about collection and recycling of old products,
please contact your local municipality, your waste disposal service or the
point of sale where you purchased the items.
Thank you for purchasing the Wireless MIDI Interface mi.1.
Be sure to read this manual before use.
After reading this manual, store it in a safe
place.
Intended Use
Included Items
Ÿ mi.1: 1
Ÿ Operation Manual (this manual): 1
Specifications
Ÿ Wireless system
Bluetooth Low Energy
Ÿ Connector plug
MIDI plug (5-pin DIN) x 2
Ÿ Power consumption 7 mW (when MIDI OUT is 3.3 V)
25 mW (when MIDI OUT is 5 V)
Ÿ Hall element switch x 1
Ÿ Magnet x 1
Ÿ LED (white) x 1
*The specifications and external appearance may change without
notice due to continuous improvements.
Safety Precautions
Be sure to read and follow the directions of the cautions described below to
prevent electric shocks, fires, injuries and malfunctions.
CAUTION
Ÿ Do not use this product for uses other than its intended use.
Ÿ Stop using this product immediately if it generates heat, smoke
or odors, or if there are any other abnormalities.
Ÿ Stop using this product immediately if it is damaged.
Ÿ Do not disassemble, alter or repair this product by yourself.
The arrows on the product show
the direction of the MIDI signal.
Use them as guides for installation.
[For business users in the European Union]
If you wish to discard electrical and electronic equipment, please contact
your dealer or supplier for further information.
For USA
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Ÿ Reorient or relocate the receiving antenna.
Ÿ Increase the separation between the equipment.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment has very low levels of RF energy that are deemed
to comply without testing of specific absorption rate(SAR).
For European Union
QUICCO SOUND Corporation hereby declares that this WIRELESS MIDI
INTERFACE mi.1 is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC and 2011/65/EU.
This statement has to be accompanied by the exact address
(http://www.quicco.co.jp/support-mi1) where a copy of the original
declaration of conformity may be found or obtained.
IN
4. Tap the “Not Connected”
next to the mi.1 in the list.
OUT
MIDI
[Information on Disposal in other Countries outside the European Union]
This symbol is only valid in the European Union. If you wish to discard
these items, please contact your local authorities or dealer and ask for the
correct method of disposal.
Wireless Precautions
mi.1 is an interface inserted into electronic musical instruments with
MIDI connectors that allows bidirectional MIDI communication
between iPhone/iPad/Mac and the instrument.
Ÿ Insert only into MIDI connectors.
Ÿ Use only as an interface for electronic musical instruments.
3. Tap the mi.1 icon in the
menu bar
5. You can now use the Piano Jukebox and other MIDI apps, such
as GarageBand
How to connect to MAC
First Step
Firmware update
Update of the firmware is recommended so that mi.1 can be used
in the most optimal condition. To do this, please download the
dedicated iPhone/iPad application "Piano Jukebox" (free) from
App Store.
Piano Jukebox
Please follow the instructions that can be
found online at:
http://www.quicco.co.jp/mi1-update
For connection between Mac, go to Application/Utilities folder
and open Audio MIDI Setup. For details please visit our website.
http://www.quicco.co.jp/how-to-connect-mi1v2
Terms of Product Warranty
For information about product warranty, returns or
troubleshooting, please see the URL below.
http://www.quicco.co.jp/support-mi1
Authorised Representative
Crestec Europe B.V
110 Teleportboulevard, 1043 EJ, Amsterdam, The Netherlands
Manufacturer
QUICCO SOUND Corporation
B-2 3-3-1, Shinmiyakoda 1-chome, Kita-ku Hamamatsu
431-2103 Japan
iPhone/iPad are registered trademarks of Apple Inc.
MIDI is a registered trademark of the MIDI Manufacturers
Association (MMA).
Bluetooth is the registered trademark of Bluetooth SIG.Inc.
©2015 QUICCO SOUND Corporation.
NF00200