™
2" Extender
Thank you for purchasing the XPORT Extender. When used with the XPORT 2" Receiver Foot this Extender allows
installation of the XPORT Passage or XPORT Traveler Uprights on vehicles requiring additional clearance (particlarly those with a rear mounted spare tire, a step bumper, or a recessed hitch).
Please read all instructions for Assembly and Installation to Vehicle before using your XPORT Hitch rack.
Note:
The minimum vehicle hitch requirement is a Class 1, bolted to the chassis.
CAUTION: IT IS THE USER'S RESPONSIBILITY TO INSURE THE SAFE AND PROPER USE OF THIS PRODUCT!
Improper attachment or misuse of this Hitch Foot or rack may result in damage to the bicycles, your vehicle or the vehicles behind you
on the road.
Contents
Part
XPORT Extender
5/8" Hitch Bolt
Washer
Part Code
QTY
A
B
C
1
1
1
Installation
1. Slide the XPORT Extender into your vehicle's 2"
receiver hitch and align the nut with the pin
hole in the hitch.
Hole 2
2. Install the Hitch Bolt and washer. Tighten securely.
3. Slide the XPORT Hitch Foot into the Extender and
align the Clevis Pin hole in the Foot with Hole 1
in the Extender. Whenever possible, use Hole 1 to
mount your rack, keeping your bikes as close as
possible to your vehicle. If extra clearance is
necessary, slide the Foot back until the Clevis Pin
hole aligns with Hole 2.
Hole 1
A
C
4. Install the Clevis Pin and Clevis Pin Clip and tighten the
Hitch Foot Knob securely, as specified in your XPORT 2"
Hitch Foot instructions.
B
Use
Check the tightness of the Hitch Bolt and Hitch Foot
Knob before every trip. It is recommended to remove
the Extender from your vehicle when not in use.
Performance Tech Support 1(800)727-2453
9am-6pm EST Monday-Friday
Performance, Inc.
One Performance Way
Chapel Hill, NC 27514
Made in USA
www.performancebike.com