Manual Before use Remote Cable kit Option SV-iG5 2. Pay attention to the following instructions. Failure to do so can result in damage of option and/or electrical shock. Configuration: 3. Installation One Remote cable kit is composed of ① Keypad mounting ① Remove keypad from inverter and put Connection fixture (loader panel), ② Connection interface on inverter interface into the same position where the keypad was side and ③ Cable. placed. 2.1 Configurations ! Caution ① Keypad mounting fixture(loader panel) zCMOS components of this option can be damaged by the static electricity. Handle carefully. zDo not change the communication wire connection when the inverter is power-on status. zMake sure the connection between inverter and “Connection interface board”. zDo not change the direction of each end of the connection wire. They are NOT compatible. Switch from keypad to Connection ② Put the keypad into keypad fixture. 1 . Introduction This manual describes how to use remote cable kit. Neglecting the procedure of this guidance of this manual may cause a damage in the related other devices and machine. LELE- ② Connection interface on inverter side ③ Put a connector of cable(end without green wire) into a connector of connection interface. ④ Put a connector of cable(end with green wire) into a connector of keypad. (Green cable is ground) A A A A ③ Cable (2 meter, 3 meter, 5 meter) A A A 2.2 LGIS code Code 053030004 053030005 053030006 LG constantly endeavor to improve our products so that information in this manual is subject to change without notice. 702100218 Ground on panel A Caution) Description SV-iG5 REMOTE 2M SV-iG5 REMOTE 3M SV-iG5 REMOTE 5M Do not use any cable or connector that is not provided by us.