SCS-150 Update - dmp.com - Digital Monitoring Products

INSTALLATION SHEET
SCS-150 Update
Software Update Using the SD Card
The Model SCS-150/UPDATE SD card comes pre-formatted and loaded with the current software update for use with
the SD (Secure Digital) card slot. When using the SCS150/UPDATE, skip to Update the SCS-150 section below. If using
an SD Card other than the SCS-150/UPDATE, follow the instructions as listed.
Before updating, make sure the SD Card is formatted for FAT32.
• Insert the SD Card into the card reader attached to your computer.
• Go to My Computer and right-click on the drive that has the card reader attached.
• Select Properties to display the Removable Disk Properties.
• If the File System displays FAT32, then you are ready to load the software onto the SD Card.
• If the File System does not show FAT32 as the File System, the SD Card needs to be formatted.
To format the SD card:
• Go to My Computer and right-click on the drive that has the card reader attached.
• Select Format to open up the Format Removable Disk window.
• Select FAT32 in the File system drop-down menu and select Start.
• To format the disk, click OK on the pop-up Warning box.
To load the software onto the SD Card:
• Locate the software download on the Dealer Direct website. Click on title to download.
• Select Save in the popup window. Save the zip file to your computer.
• Extract the zip file onto the SD Card. There should be two files extracted on the SD card: SCS150a.bin and
SCS150b.bin. Note: These two files need to be placed on the root directory of the SD card, not inside a folder.
Update the SCS-150:
• Set the S2 dip switches on the SCS-150 to 1101 (ON ON OFF ON).
• Insert a FAT32 formatted SD card with the new software into the SD card slot on the SCS-150 processor board.
• Reconnect the keypad to the J15 header.
• Insert the SCS-150 processor board into the SCS-1R and power up. Observe the display for programming status.
• When finished with the update the SCS-1R display instructs you to remove the SD Card.
• Remove the SCS-150 board and remove the SD card from the SCS-150 board.
• Reset the dip switches to 0000 (OFF OFF OFF OFF) and replace the SCS-150 board and cables.
Backplane Connection
SCS-150
Battery
Dip Switches
ON
S2
1234
Keypad
J15
LEDs
Memory
J7
A3
A2
A1
8
7
6
5
J6
4 3 2
1
SD
Card
LT-1056 © 2011 Digital Monitoring Products, Inc.
13385
Reset