Kingston Technology ValueRAM KVR1066D3N7/1GBK memory module

Memory Module Specification
KVR1066D3N7/1G
1GB 128M x 64-Bit PC3-8500
CL7 240-Pin DIMM
DESCRIPTION:
This document describes ValueRAM's 128M x 64-bit (1GB) DDR3-1066 CL7 SDRAM (Synchronous DRAM) memory
module, based on eight 128M x 8-bit DDR3-1066 FBGA components. The SPD is programmed to JEDEC standard
latency 1066Mhz timing of 7-7-7 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. The
electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
533MHz fCK for 1066Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 6 (DDR3-1066)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), single sided component
PERFORMANCE:
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh Command Time (tRFCmin)
Row Active Time (tRASmin)
Power
UL Rating
Operating Temperature
7 cycles
50.63ns (min.)
110ns
37.5ns (min.)
0.600 W (operating)
94 V - 0
0o C to 85o C
Storage Temperature
-55o C to +100o C
Document No. VALUERAM0570-001.B00
04/06/10
Page 1
ValueRAM
MODULE DIMENSIONS:
T E C H N O L O G Y
133.35
Units: millimeters
30.00
18.80
15.80
11.00
8.00
Document No. VALUERAM0570-001.B00
54.70
0.00
0.00
Page 2