Kingston Technology ValueRAM KVR1333D3D4R9SK3/24

Memory Module Specifications
KVR1333D3D4R9SK3/24G
24GB (8GB 1024M x 72-Bit x 3 pcs.) PC3-10600
CL9 Registered w/Parity 240-Pin DIMM Kit
DESCRIPTION
ValueRAM’s KVR1333D3D4R9SK3/24G is a kit of three
1024M x 72-bit 8GB (8192MB) DDR3-1333MHz CL9 SDRAM
(Synchronous DRAM) registered w/parity, dual-rank memory
modules, based on thirty-six 512M x 4-bit DDR3-1333MHz
FBGA components per module. Total kit capacity 24GB. The
SPDs are programmed to JEDEC standard latency 1333MHz
timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact
fingers and requires +1.5V. The electrical and mechanical
specifications are as follows:
FEATURES
SPECIFICATIONS
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin)
160ns (min.)
Row Active Time (tRASmin) 36ns (min.)
Power 4.365 W (operating per module)
UL Rating 94 V - 0
Operating Temperature 0° C to 85° C
Storage Temperature -55° C to +100° C
• JEDEC standard 1.5V ± 0.075V Power Supply
• VDDQ = 1.5V ± 0.075V
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 6,7,8,9,10
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does
not allow seamless read or write [either on the fly using A12
or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through
ZQ pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• On-DIMM thermal sensor (Grade B)
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE ≤ 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component
Continued >>
Kingston.com
Document No. VALUERAM0864-001.A00
09/23/09 Page 1
continued
ValueRAM
MODULE DIMENSIONS:
Kingston.com
Document No. VALUERAM0864-001.A00
09/23/09 Page 2