- Computers & electronics
- Print & Scan
- Printing supplies
- Toners & Laser Cartridges
- Lanier
- 4800038
- Data Sheet
advertisement
MATERIAL SAFETY DATA SHEET
Lanier Worldwide, Inc.
2300 Parklake Drive, NE
Atlanta, GA USA 30345-
2979
Emergency Telephone: 800-526-4371
Section 1: Chemical Product and Company Information
Identity: 5455 Toner
Product ID: 480-0038
Synonyms
& Common Toner for Lanier LD055, 5455, 5470
Names:
Uses:
Chemical
Formula:
Lanier 5455, 5470 LD055
Mixture
MSDS No. CP- 338
Issued: 03/01/2003
Supersedes:
Date:
Prepared by:
03/01/00
03/01/2003
EH&S Department 770-496-9500
Approved by:
European
Contact:
Larry Choskey, Manager, CEH&S
Walter Fricke, Manager, Safety &
Environment,
Lanier Worldwide, Inc.
Im Taubental D -41468 Neuss,
Germany +49-2131-387-177
Polyester resin
Styrene acrylic polymer
Carbon black
Section 2: Composition / Information on Ingredients
PERCENT
60 – 80
10 – 30
7 – 15
CAS No.
Confidential
25767-47-9
1333-86-4
Wax < 5 8015-86-9
Dye
*PEL as the product: 15mg/m
3
*TLV as the product: 10mg/m
< 1
3
(total dust), 5mg/m
(total dust), 5mg/m
3
31714-55-3
(respirable dust)
3
(respirable dust)
EXPOSURE LIMITS
3
8 mg/m
10 mg/m
3
Not listed
3
3.5 mg/m
3.5 mg/m
3
Not listed
Not listed
Section 3: Hazards Identification
HMIS Rating:
FLAMMABILITY = 1 HEALTH = 1
REACTIVITY = 0 SPECIAL = none
SOURCE
ACGIH TWA
ACGIH STEL
N/a
OSHA PEL
ACGIH TWA
N/a
N/a
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non-toxic dust. May cause gasping if inhaled. Inhalati on should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): Prolonged inhalation of excessive dust may cause lung damage. It is attributed to “lung overloading”, a generic response to excessive amounts of any dust retained in the lungs for a prolonged interval. Use of this product, as intended, does not result in inhalation of excessive dust.
Carcinogenicity: Carbon Black was reclassified as a Group 2B by the IARC in 1996 based upon the result of only the inhalation study in rats. However, there was not observed the incidence of tumors on the test results on dermal or oral studies. Also, 2 years inhalation study using a typical toner containing carbon black showed no association between toner exposure and animal tumors.
Inhalation:
Skin Contact: Wash with soap and water.
Section 4: First Aid Measures
Gargle with water. Remove to fresh air if effects occur. Get medical attention if needed. Eye Contact:
In case of contact, immediately flush eyes with water for 15 minutes. Get medical attention if needed.
Ingestion: Dilute stomach contents with several glasses of water. Get medical attention.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO
2
, dry chemical, foam or water.
Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a
Extinguishing media which may not be used for safety reasons: none
y o u r d o c u m e n t m a n a g e m e n t p a r t n e r
MATERIAL SAFETY DATA SHEET
Page 2 of 3 cp338
Section 6: Accidental Release Measures
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the
Atrix AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
Special Handling:
Special Storage:
Section 7: Handling and Storage
Cleanse skin after contact before breaks or meals, and end of workday.
Do not handle in areas where the wind blows.
Minimize the breathing of dust.
Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.
Eye Protection: none required under normal use. Skin Protection: none required under normal us e.
Section 9: Physical and Chemical Properties
CHARACTERISTICS:
Appearance:
Form:
Specific gravity:
Bulk Density:
Black
Powder
Odor: Slight plastic odor
Solubility in Water: Insoluble
N/a
1.2 g/cm
3
Melting point:
Vapor pressure:
Vapor density:
Evaporation rate:
Boiling point:
N/a
N/a
N/a
N/a
N/a
Section 10: Stability and Reactivity
Conditions to avoid: none Materials to avoid: none Stability: Stable
Hazardous decomposition products: Styrene
Section 11: Toxicological Information:
Ames test negative Acute skin irritation: Non-irritant
Acute oral toxicity: >5000mg/kg (rat) Acute allergenic effects: non-skin sensitive
Special effects: Carcinogenicity: In 1996 the IARC reclassified Carbon Black as a Group 2B carcinogen (possible human carcinogen). This evaluation is given to carbon black for which there is inadequate human evidence, but sufficient animal evidence. The latter is based upon the development of lung tumors in rats receiving chronic inhalation exposures to free carbon black at levels that induce particle overload of the lung. Studies performed in animal models other than rats have not demonstrated an association between carbon black and lung tumors. Moreover, 2 -years cancer bioassay using a typical toner preparation containing carbon black did not demonstrate an association between toner exposure and tumor development in rats.
Section 12: Environmental / Ecological Information
Acute toxicity to fish: >500 (mg/kg/96hr) Bioaccumulation: Not known in bioaccumulation
Acute toxicity to daphnia: Not available Persistence/Degradability: Not known
Algae inhibition test: Not available
Section 13: Disposal Consideration
Used Toner should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose or spilled Toner.
Section 14: Transportation Information
International regulations:
RID/ADR Not applicable
DOT 49 CFR
ADNR
Not applicable
Not applicable
ICAO-TI/ATA-DGR
UN Classification Number
IMDG Code
Not applicable
Not applicable
Not applicable
MATERIAL SAFETY DATA SHEET
Page 3 of 3 cp338
Specific precautionary transport measures: Avoid direct sunlight. Do not keep over 35
?
C (95
?
F).
Specific material to avoid: None in normal use.
Section 15: Regulatory Information
Regulation: Not known
Section 16: Miscellaneous Information
Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser.
Therefore, although reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no warranties, makes no representations, and assumes no responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for consequences of its use. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the only hazards that exist.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project