Da-Lite Advantage Deluxe Electrol

ADVANTAGE® DELUXE
ELECTROL® (UP TO 12' x 12')
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: 574-267-8101
800-622-3737
Fax: 574-267-7804
Toll Free Fax: 877-325-4832
www.da-lite.com
e-mail: info@da-lite.com
Automatic Electric Projection Screen Model
SPECIFICATION DATA
SUGGESTED SPECIFICATIONS: projection screen(s),
(H) x (W). The Advantage® Deluxe
Screen shall have two motors, one to operate door and one to operate screen. Door motor electrically operated 120 volt (60 Hz) not more
than 1.2 amp, mounted inside the roller, to be three wire with ground, quick reversal type, oiled for life, with automatic thermal overload
cutout, integral gears, capacitor and an electric brake to prevent coasting. To have pre-set but adjustable limit switches to automatically
stop fabric door in the ”down“ position. The door will lift to the closed position where a micro switch shall cut off the electrical current to
the door motor. Screen motor is electrically operated 120 volt (60 Hz) not more than 2.4 amp, mounted inside the roller, to be three wire
with ground quick reversal type, oiled for life, with automatic thermal overload cutout, integral gears, capacitor and an electric brake to
prevent coasting. To have pre-set but adjustable limit switches to automatically stop picture surface in the ”up“ and ”down“ positions.
The roller to be of rigid metal. Screen fabric to be flame retardant and mildew resistant fiberglass with black masking borders standard.
Bottom of fabric shall be formed into a pocket holding a metal rod with plastic caps. Case shall be a white powder coated aluminum
extrusion. Bottom of case to be self-trimming with a built-in flange around the bottom of the case. A section of the bottom of the case
shall be an aluminum door equipped with concealed hinges so that it opens and closes automatically with the lowering and raising of the
picture surface. The balance of the bottom of the case shall be a second hinged aluminum door with manual opening to provide access.
Junction box shall be internally integrated into the housing making it possible to install the housing and wire to the building’s electrical
system during construction. The junction box shall contain a quick connect connector that is mounted in the housing for easy plug-in
connection to the motorized fabric and roller assembly. The motorized fabric and roller assembly to be installed in the case at the factory
or at a later time at the job site. To be complete with integrated low voltage control unit and three position control switch with cover plate.
Suitable for use in environmental air space in accordance with section 300-22 (c) of the National Electric Code, and sections 2-128, 12-010
(3) and 12-100 of the Canadian Electrical Code, part 1, CSA C22.1. Screen to be listed by Underwriters’ Laboratories.
Matte White: Horizontal seam required when both dimensions exceed 10'.
High Contrast Matte White: Available in sizes where both dimensions do not exceed 10'. Project:
Video Spectra 1.5 : Available in sizes where both dimensions do not exceed 8'.
High Power®: Available in sizes up to and including 9' x 12'. Horizontal seam
Architect:
required when both dimensions exceed 6'.
Phone:
WHEN ORDERING, MARK APPROPRIATE SELECTIONS:
Select size from charts on the other side.
Select viewing surface:
o Matte White o High Contrast Matte White o Video Spectra 1.5
o High Power® o High Contrast High Power®
GREENGUARD® and GREENGUARD® Children and Schools Certified.
Optional Accessories:
o Extra Drop available to lower picture area more than normal. Specify total drop
at top _____ (black
orwhite)
white) or at bottom _____ (black
or white)
white). 13' maximum
(black or
(black or
total surface height including picture area.
o No borders (Black masking borders standard).
o Wireless Remote Control for LVC.
o Radio Frequency Remote
o Radio Frequency Range Extender available
o Infrared Remote
o Key Locking Cover Plate for 120 V Switch or LVC.
o 220/240 Volt (50 Hz) Motor.
o Video Projector Interface Control - built-in
o SCB-100 RS-232 Serial Control Board - external.
o NET-100 Ethernet-Serial Adapter
o SCB-100 RS-232 Serial Control Board - built-in
o NET-100 Ethernet-Serial Adapter
SUGGESTED CEILING
INSTALLATION
VARIABLE POSITION
MOUNTING BRACKETS
Contractor:
Phone:
Supervisor:
Phone:
Supplier:
Date:
Revised:
91/4"
(SUGGESTED) 3/8"
THREADED ROD
(NOT INCLUDED)
ATTACHED TO
MOUNTING BRACKET
71/4"
71/4"
FINISHED
CEILING
SELF-TRIMMING
FLANGE
71/4"
CASE LENGTH
83/4"
DOOR ROLLER
61/8"
MOTOR END
SCREEN ROLLER
AUDIENCE
SIDE
ELECTRICAL
JUNCTION BOX
61/8"
SELF-TRIMMING
FLANGE
SCREEN DOOR
ACCESS DOOR
33/8"
53/8"
Viewing Area
H x W
Cm
43" x 57"
109 x 145
50" x 67"
127 x 170
57" x 77"
145 x 196
60" x 80"
152 x 203
69" x 92"
175 x 234
87" x 116"
221 x 295
105" x 140"
267 x 356
120" x 160"
305 x 406
Viewing Area
H x W
Cm
45" x 80"
114 x 203
52" x 92"
132 x 234
54" x 96"
137 x 244
58" x 104"
147 x 264
65" x 116"
165 x 295
78" x 139"
198 x 353
90" x 160"
229 x 406
Viewing Area
H x W
Cm
50" x 80"
127 x 203
571⁄2" x 92"
146 x 234
60" x 96"
152 x 244
69" x 110"
175 x 279
721⁄2" x 116"
184 x 295
87" x 139"
221 x 353
100" x 160"
254 x 406
Sizes
H x W
50" x 50"
60" x 60"
70" x 70"
84" x 84"
6' x 8'^
8' x 8'
7' x 9'^
9' x 9'^
8' x 10'^
10' x 10'^
9' x 12'^
12' x 12'
VIDEO (NTSC 4:3) FORMAT DIMENSIONS (2" standard black drop at top)
Nominal Diagonal
Overall Length of Case (does not include flange)
In.
Cm
In.
Cm
72"
183
72¼"
184
84"
213
82¼"
209
96"
244
96¼"
244
100"
254
96¼"
244
120"
305
108¼"
275
150"
381
132¼"
336
180"
457
156¼"
397
200"
508
176¼"
448
Approx. Ship. Wt.
Lbs.
Kg
83
37.6
93
42.2
114
51.7
118
53.5
128
58.1
165
74.8
190
86.2
198
89.8
HDTV (16:9) FORMAT DIMENSIONS (2" standard black drop at top)
Nominal Diagonal
Overall Length of Case (does not include flange)
In.
Cm
In.
Cm
92"
234
96¼"
244
106"
269
108¼"
275
110"
279
112¼"
285
119"
302
120¼"
305
133"
338
132¼"
336
159"
404
156¼"
397
184"
467
176¼"
448
Approx. Ship. Wt.
Lbs.
Kg
122
55.3
137
57.6
141
64.0
153
69.4
165
74.8
190
86.2
198
89.8
WIDE (16:10) FORMAT DIMENSIONS
Nominal Diagonal
Overall Length of Case (does not include flange)
In.
Cm
In.
Cm
94"
239
96¼"
244
109"
277
1081⁄4"
275
113"
287
112¼"
285
130"
330
126¼"
321
137"
348
132¼"
336
164"
417
156¼"
397
189"
480
176¼"
448
Approx. Ship. Wt.
Lbs.
Kg
120
54.4
13862.6
141
64.0
161
73.0
165
74.8
190
86.2
198
89.8
SQUARE FORMAT DIMENSIONS (screens with ^ have 2" standard black drop at top)
Overall Length of Case (does not include flange)
Approx. Ship. Wt.
Cm
In.
Cm
Lbs.
Kg
127 x 127
62¼"
158
71
32.2
152 x 152
72¼"
184
81
36.7
178 x 178
82¼"
209
104
47.2
213 x 213
96¼"
244
115
52.2
183 x 244
108¼"
275
128
58.1
244 x 244
108¼"
275
131
58.4
213 x 274
120¼"
305
136
61.7
274 x 274
120¼"
305
149
67.6
244 x 305
132¼"
336
165
74.8
305 x 305
132¼"
336
176
79.8
274 x 366
156¼"
397
190
86.2
366 x 366
156¼"
397
200
90.7
Overall case length dimensions ±¼" (6mm).
Detail dimensional drawings, wiring diagrams and installation instructions available upon request.
Specifications subject to change without notice.
Custom formats and sizes available upon request.
Rev. 5/11