Model VX0 Horizontal Feet Kit
Installation Instructions
Use the following instructions to mount the thin client to the horizontal feet kit.
1. Rotate the thin client until the power button is to the right of the front connectors;
position the horizontal feet onto the left and right spines of the thin client and slide them
toward the front until they snap in place. The first feet snap twice, once over the first
locator position and then again at the second locator position.
Leave at least 12.5 mm between the ventilation holes of the thin client and
any solid surface. An enclosed area must have a minimum of 150 square cm
of venting or other open area to maintain proper ventilation of the thin client.
883864-01 Rev. A
March 2005
Download PDF
Similar pages
Dell Wyse V30L
Dell Wyse 1GB Flash
Dell Wyse 512MB RAM
Dell Wyse 1GB RAM
GBC CombBind Spines
Ch 3 part 2: Projectile Motion and Vectors in 2...