OptReboot works seamlessly with an existing OptConnect cellular

OptReboot works seamlessly with an existing OptConnect cellular gateway, enabling
you to remotely reboot your ATM, Kiosk, Point of Sale, or any other similar device from
an internet connected computer, tablet, or smart phone. Your OptReboot comes
pre-configured and simply needs to be connected using the included cabling.
Open the ATM’s lower cabinet to access the ATM’s and OptConnect gateway’s power
supply. The OptReboot is designed to be installed in this lower cabinet.
Locate An Available Ethernet Port: Looking at the back of the OptConnect cellular
gateway, determine if you have an open ethernet port.
If the ethernet port is already occupied by a connection to an ATM, Kiosk, or other
device, continue to step 3a. If the port is available, skip directly to step 3b.
Connecting Network Connections
3a Connect Using A Network Switch: These steps are required only if your OptConnect
gateway’s ethernet port is occupied. The OptReboot is compatible with any network
switch (one may have been included in your shipment).
a) Disconnect your ATM, Kiosk, or other device from the OptConnect gateway.
Network Switch
STATUS
RESET
OptConnect Gateway
Network Switch
ETHERNET
CELL
ON
S
I
G
N
A
L
b) Connect your
device’s ethernet
cable to a port on a
network switch.
d) Connect an
ethernet cable
between the
OptConnect
gateway and the
networt switch.
Network Switch
OptReboot
c) Connect an ethernet
cable between
the OptReboot’s
ethernet port and a
port on the network
switch.
See overall Network Connection diagram on back.
3b Connect Using Direct Connection:
a) Connect the included ethernet cable between the ethernet port
on the OptConnect gateway and the OptReboot’s ethernet port.
OptReboot
OptConnect Gateway
STATUS
ETHERNET
CELL
ON
RESET
S
I
G
N
A
L
4
OptReboot (AC Input)
A/C Output
Electrical Connections
a) Connect the OptReboot’s power cord to it’s A/C Input
connection and to a wall outlet. See figure 1.
b) Connect the OptReboot’s short electrical pigtail cable to it’s
A/C Output connection. See figure 2.
c) Connect your ATM’s, Kiosk’s, or other device’s power cord
to the OptReboot’s short electrical pigtail cable. See figure 2.
d) Confirm the red “Outlet On” light is illuminated on the
OptReboot device. If it’s not, please call technical support.
Outlet On
See overall electrical connection diagram below.
OptReboot
(AC Output)
Short Electrical
Pigtail Cable
Note: Please do not use the recessed reset button on the OptReboot
device. Resetting it will lose all programming associated with your
unique installation and the device will not function properly.
OptReboot (AC Input)
Network Switch
OptReboot
A/C Output
Outlet On
OptReboot (AC Output)
Network Switch
Short Electrical
Pigtail Cable
POWER
UNLOCK LOCK
+5V
STATUS
RESET
ETHERNET
CELL
ON
S
I
G
N
A
L
AUX
MAIN
OptConnect Gateway
OptConnect Gateway
Warning: The OptReboot is designed to connect to a single device. By connecting a multipleoutlet power strip to the OptReboot, multiple devices can be controlled. However, please be
aware connecting multiple devices may cause damage to all attached devices. The electrical
load of all devices controlled by OptReboot must not exceed 12 amps. Please consult your
device manufacturers’ documentation to ensure the combined start up load of all connected
devices does not exceed this amperage.
Need Help? Feel free to contact us with any questions at 1-877-678-3343.
Download PDF
Similar pages
Set up Guide
H4882BP Single Navitronic Oven Spec.pmd
N A V I G A T I O N
V O I C E R E C...
Bridge Mode Setup Guide
null 21333811
Broadband Link Advanced Settings
ATM4PS CKIT