Auto Sensing - To let the printer re-adjust the label

Auto Sensing - To let the printer re-adjust the label:
Printer can automatically detect label length and record. By
this way, without setting the print length, the printer can accurately detect the label (black mark) positions.
1 Check if the Moveable Sensor Mark is located at the right sensing
covered by
Moveable sensor
2 Power off the printer, press and hold the Feed key.
3 Press and hold the PAUSE button while power on the printer,
after the printer makes 3 beeps, and wait until the LED READY light
flashes orange and the LED STATUS light turns orange, the printer
will go into the Auto Sensing Mode. Then release the FEED button.
Power on the printer
Press & hold PAUSE Button
Please refer to User's Manual for all settings
Copyright 2009 VIC COMPUTER(HK)CO.,LTD All Rights Reserved
K:\Products\Product Technical\BC\BC-PGE1200\
Download PDF
Similar pages