PRO 63 CARDIOID DYNAMIC MICROPHONE
PRO 63 SPECIFICATIONS†
• Ideal for musical instrument pickup and general use
ELEMENT
Dynamic
POLAR PATTERN
Cardioid
FREQUENCY RESPONSE
70-16,000 Hz
OPEN CIRCUIT SENSITIVITY
–55 dB (1.7 mV) re 1V at 1 Pa*
IMPEDANCE
300 ohms
WEIGHT (less cable and accessories)
10.9 oz (309 g)
DIMENSIONS
7.17" (182.1 mm) long,
1.63" (41.4 mm) head diameter
OUTPUT CONNECTOR
Integral 3-pin XLRM-type
CABLE
15.0' (4.5 m) cable with XLRF-type
connector at microphone end,
XLRM-type connector at equipment
end
ACCESSORIES FURNISHED
AT8470 Quiet-Flex™ stand clamp for
5
/8"-27 threaded stands;
5
/8"-27 to 3/8"-16 threaded adapter;
soft protective pouch
• Hi-ENERGY® neodymium magnet for improved output and
transient response
• Two-stage screen reduces wind noise and “popping” during close
use
†In the interest of standards development, A.T.U.S. offers full details on its test
methods to other industry professionals on request.
*1 Pascal = 10 dynes /cm 2 = 10 microbars = 94 dB SPL
Specifications are subject to change without notice.
• Corrosion-resistant contacts from gold-plated XLRM-type
connectors
• Tailored response provides natural, full-range reproduction
Frequency Response
Polar Pattern
0
330
30
300
• Cardioid polar pattern reduces pickup of sounds from the sides
and rear, improving isolation of desired sound source
Output from the microphone’s XLRM-type connector is low
impedance (Lo-Z) balanced. The signal appears across Pins 2 and
3; Pin 1 is ground (shield). Output phase is “Pin 2 hot” – positive
acoustic pressure produces positive voltage at Pin 2.
Plug Type
XLR
1
/4" “TRS”
1
/4"
Ground
Pin 1
Sleeve
Sleeve
Audio “+”
Pin 2
Tip
Tip
60
10 dB
90
270
240
120
50
210
180
100
500
200
1k
2k
5k
10k
20k
Frequency in Hertz
150
LEGEND
SCALE IS 5 DECIBELS PER DIVISION
12" or more on axis
LEGEND
200 Hz
1 kHz
5 kHz
8 kHz
Audio “–”
Pin 3
Ring
Sleeve
To avoid phase cancellation and poor sound, all mic cables must be
wired consistently: Pin 1-to-Pin 1, etc. For a high-impedance (Hi-Z)
mic input, connect a Lo-Z balanced cable to a Hi-Z matching
transformer (A-T CP8201 or equal) at the equipment input.
When using the PRO 63 in settings with a stage monitor speaker,
the speaker should be located 180° off axis (at the rear of the
microphone). This placement, in conjunction with the microphone’s
uniform cardioid pickup pattern, will virtually eliminate the possibility
of undesired audio feedback.
Take care to keep foreign particles from entering the windscreen.
An accumulation of iron or steel filings on the diaphragm, and/or
foreign material in the windscreen’s mesh surface, can degrade
performance.
Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224
Audio-Technica Limited, Old Lane, Leeds LS11 8AG England
www.audio-technica.com
P3893-00210
P51683-EN
©2004 Audio-Technica U.S., Inc.
Printed in Taiwan
Response in dB
• Rugged design and construction for reliable performance