Altronix AL125ULE power extension Datasheet

AL125ULE Multi-Output

Power Supply Charger w/Fire Alarm Interface

Rev. DSAL125ULE - A26F

Overview

• This Altronix power supply converts a 24VAC/40VA input, to a

12VDC @ 1 amp of total supply current or 24VDC @ .5 amp of total supply current Class 2 Rated power limited output.

Specifications

• 12VDC or 24VDC selectable output.

• 1 amp @ 12VDC or .5 amp @ 24VDC of supply current.

• Two (2) PTC protected Class 2 Rated power limited outputs.

• Filtered and electronically regulated output.*

• Short circuit and thermal overload protection.

• Built-in charger for sealed lead acid or gel type batteries.

• Maximum charge current: .4 amp

• Automatic switch over to stand-by battery when AC fails.

• AC power and unit status indicator on the front panel.

• Normally Open [NO] trigger input.

• Supervised Fire Alarm Disconnect

(Latching w/reset or Non-Latching).

• Power supply board and enclosure.

*Note: When unit is powered by battery back up (AC Fail condition) the voltage range is 9.3V-13.2V and

19.55V-26.4V for 12 and 24 volt operation respectively.

Agency Approvals

UL Listed for Access Control System Units

(UL 294).

NYC Department of Buildings Approved.

CUL Listed - CSA Standard C22.2 No.1-98,

Audio, Video and Similar Equipment.

1.00”

1.00”

1.25”

3.85”

0.50”

Enclosure Dimensions

8.5"H x 7.5"W x 3.75"D

3.625”

1.25”

3.85”

7.25”

6.05”

1.25”

1.00”

6.825” 8.125”

1.75”

1.00”

1.00”

Access for Linecord

5.25”

7.25”

3.85”

1.00”

Altronix Corp. - 140 58th Street, Brooklyn, NY 11220 • 718-567-8181 • 888-258-7669 • altronix.com