- Computers & electronics
- Computer components
- System components
- Memory modules
- Kingston Technology
- KVR16LE11/8KF
- Data Sheet
advertisement
Memory Module Specifi cations
KVR16LE11/8KF
8GB 2Rx8 1G x 72-Bit PC3L-12800
CL11 240-Pin ECC DIMM
DESCRIPTION
This document describes ValueRAM's 1G x 72-bit (8GB)
DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, ECC, low voltage, memory module, based on eighteen 512M x 8-bit
FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V.
This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
FEATURES
•
JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
•
800MHz fCK for 1600Mb/sec/pin
•
8 independent internal bank
•
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
•
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•
8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or
MRS]
•
Bi-directional Differential Data Strobe
•
Thermal Sensor Grade B
•
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
•
On Die Termination using ODT pin
•
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•
Asynchronous Reset
•
PCB: Height 1.18” (30mm), double sided component
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
11 cycles
48.125ns (min.)
260ns (min.)
35ns (min.)
(1.35V) = 2.041 W*
94 V - 0
0 o C to 85 o C
-55 o C to +100 o C
*Power will vary depending on the SDRAM.
SDRAM SUPPORTED
Kingston (F-Die)
Continued >>
Document No. VALUERAM1375-001.B00 12/03/13 Page 1
MODULE DIMENSIONS:
T E C H N O L O G Y
30.00
18.80
15.80
11.00
8.00
0.00
Units: millimeters
133.35
Document No. VALUERAM1375-001.B00 Page 2
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project