QCE12U

QCE24U

QCE42U

CAUTION: A forklift must be used by a trained driver to safely remove the cabinet from the pallet.

Instructions for Removing a QuietCab Elite

™

Cabinet from a Pallet Using a Forklift Truck

1. Make sure the pallet is placed on a flat, even surface.

Remove the straps and then the sides from the crate

(use a mallet). Leave the bubble-wrapped cabinet on the pallet.

2. To remove the cabinet from the pallet, make sure the forklift is facing the front or rear of the cabinet (not the sides). Carefully place forks through the aperture

BLACK BOX

CAUTION: Toppling hazard! A person should stand on each side of the cabinet to help balance it during lifting.

3. Gently lift away from the pallet, making sure the cabinet is properly balanced on the forks.

Instructions for Removing a QuietCab Elite Cabinet from a Pallet without Using a Forklift Truck

1. Make sure the pallet is placed on a flat, even surface.

Remove the straps and then the sides from the crate (use a mallet). Leave the bubble-wrapped cabinet on the pallet.

2. While the cabinet is still on the pallet, remove the packaging and bubble wrap. The cabinet is heavy, so remove the front and rear doors and the side panels.

3. Once all the cladding has been removed, the frame should be light enough for 2 or 3 people to lift it off the pallet.

NOTE: Place the frame where you want it to remain before replacing the cladding.

CAUTION: Make sure the doors and side panels are placed against a solid wall on a clean, even surface after removing them from the cabinet.

© Copyright 2012. Black Box Corporation. All rights reserved. Black Box and the Double Diamond logo are registered trademarks, and Elite is a trademark, of BB Technologies,

Inc. Any third-party trademarks appearing in this document are acknowledged to be the property of their respective owners.

724 -746 -5500 | blackbox.com