Brodit ProClip 532390 Datasheet

Holder and Charging Specifications
Item no 530390, 532390 (Reference doc 311-1166)
Hytera PD702, PD785g, PD782
Features & Benefits














Always keep your battery fully charged
Made of high grade ABS plastic
Charges Li-Ion or Li-Poly batteries
Works in 12 and 24 volt vehicles
Rapid and trickle charges radio
LED Red to Green charging status indicator
Custom fit to hold device securely
Designed and manufactured in Sweden
Allows one-handed insertion and removal of radio
You can charge just the battery alone in the holder
Works with or without belt clip on back of radio
Charging cable attached to holder providing dock type connection
Attach to ProClip Vehicle or Pedestal mounts
Can also be attached directly to any flat surface,
dashboard, console wall, or any type of mounting bracket
Holder specifications item no 530390 – Charging Holder with Cigarette Lighter Plug
Material
Dimensions (W x H x D)
Weight
Cable Length
Attachment
Rugged thermal resistant black ABS plastic (FT103)
64 x 105 x 47 mm
134 g / 0.29 lbs
54 cm
AMPS hole pattern
Holder specifications item no 532390 – Charging Holder for Hard Wire Installation
Material
Dimensions (W x H x D)
Weight
Cable Length
Attachment
Rugged thermal resistant black ABS plastic (FT103)
64 x 105 x 47 mm
118 g / 0.26 lbs
142 cm
AMPS hole pattern
Charging Specifications
Lithium-based
Lithium charging is based on CVCC (Constant Voltage Constant Current). The charging procedure is as
follows:
If the battery is empty or has low charge a constant current charges the battery until the cell voltage
reaches 8,4V. The LED emits red light. Hereafter the charge continues until the current goes down to 0A.
The battery is now full and stays fully charged. A special designed voltage controller is monitoring that the
cell voltage is within limit. The LED emits green light.
If the battery is used without disconnecting the charger, current is supplied directly resulting in a fast
recovery.
Battery Chemistry
Input Voltage
Charging Voltage
Timer for Max. Charging Time
Max. Charging Time
Rapid Charge
Trickle Charge
LED Charging Indicator
Temperature Control
Operating Temperature
EMI/RFI
Environmental
Electrical Testing
Input Transient Protected
Output Short Circuit Protected
Li-ion or Li-Poly batteries
11-30 V
8.4 V
Automatic, stops at 8.4 V
2-3 hours depending on battery capacity
1 A +/- 5%
0 to 50 mA
LED Red to Green indicator
Controlled by battery
-40° C to + 50° C / -40° F to 122° F
(can be restricted by battery chemistry)
CE, E, FCC Part 15 Class B, ICES-003 Class B
RoHS Compliant
ISO 7637 and SAE J1455
Withstands +200V & -600V.
A 2,5A fuse is mounted on the incoming supply.
The charger will supply a maximum current of 1 A which protects both
the charger and the connected equipment. The current limit is set to
standards of the producer and shall not be higher.