APC NETBOTZ NBES0306 Installation instructions

NetBotz

®

Vibration Sensor (NBES0306)

Installation Instructions

Inventory

22-mm (7/8-in) hook and loop fastener (1)

203-mm (8-in) tie wrap (10)

Vibration sensor with 3.65-m (12-ft) cable (1)

Adhesive cable tie holder (5)

Installation

Caution: Make sure you connect this sensor to a Sensor port on applicable

NetBotz products. See your NetBotz product documentation for details.

Note: The typical location for the vibration sensor is on a main support in the top half of the enclosure. Avoid installing the sensor near a cooling unit, which could cause the sensor to give false alarms.

Note: You can extend the length of the sensor cable up to 30.5 m (100 ft) using the

RJ-45 coupling and standard CAT-5 cabling.

RJ-45 coupling (1)

Customer support and warranty information is available at the APC Web site, www.apc.com.

© 2008 American Power Conversion. All rights reserved. All APC trademarks are property of American

Power Conversion. Other trademarks are property of their respective owners.

990-3376

5/08

*990-3376*