advertisement
IMPORTANT:
The "User Operating
Card" must be left with
Visidec Focus Articulated
Arm once installed.
VF-AT-AA
Component Checklist
Installation Instructions
Focus Accessory Arm
Hardware
Primary Arm
Cable Cover
M4x10mm
(4x)
M4x12mm
(4x)
M4x16mm
(4x)
Articulated Arm Hand Grip Secondary Arm
Cable Cover
Display Mounting
Screws
IMPORTANT INFORMATION:
! IMPORTANT - Install Visidec Focus Accessory Arm as per Installation Instructions.
! This product is designed to be installed onto an existing Visidec Focus pole mount.
! This products supports displays with a maximum weight of 8kg (17½ lbs), and VESA mounting hole configurations:
75 x 75mm (3" x 3"), 100 x 100mm (4" x 4").
! The manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
Step 2. Remove Top Cap
Pole Top Cap
UP
Pole of the existing Visidec
Focus Product
Step 3. Attached Articulated Arm to the Existing Visidec Focus Product
Articulated Arm
Lip of the Pole
Hand Grip tab
Pole
A. Slightly insert Articulated Arm.
B. Hold Articulated Arm at the lip of
the pole and insert Hand Grip tab
in the Articulated Arm.
Ensure the tab lines up with the slot
in the Pole.
C. Slide down Articulated
Arm with Hand Grip to
the desired position.
D. Twist and lock the Hand Grip.
Note: DO NOT
OVER TIGHTEN
Step 4. Fasten Display to Articulated Arm
M4 Display Mounting Screws
For displays with 75 x 75mm
(3" x 3") mounting hole patterns
Step 5. Replace Top Cap
Pull out tabs
M4 Display Mounting Screws
For displays with 100 x 100mm
(4" x 4") mounting hole patterns
INSERT
Step 6. Cable Management - Ensure arm is fully extended
Route the Cables underneath the Arms, inserting the Primary and Secondary Arm
Cable Covers to hold the Cables in place.
To insert Cable Covers:
INSERT
Secondary Arm
Cable Cover
Primary Arm
Cable Cover
TIP: Leave enough slack in the cables at the joints to allow full movement.
Insert cables into the pole slot using the
Cable Balls (supplied with the Visidec Focus
Mount) to hold them in place.
INSERT
Installation Complete
A. Insert Tabs
B. Push In
C. Then Push Up
NOTE: If the Articulated Arms are to be used in a multi-user environment, use the Cable Clip
(supplied with the Visidec Focus
Mount) to secure the cables to the pole.
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without noticed. Published 06.09.12
advertisement
Related manuals
advertisement