INSTALLATION INSTRUCTIONS
SELF SERVE ICE DISPENSE LEVER
KIT P/N 08054
This kit applies to the following models: TJ300/400
Table 1. Loose-Shipped Parts
Item
No.
Part No.
1 15415
2 27107
3 70016
4 70045
5 70242
Lever Assembly
Bracket, Dispenser Mounting
Hex Nut, 10--32
Lock Washer, #10
Phil. Hd Scr., 10--32 x 3/8
Name
IMI CORNELIUS INC.
One Cornelius Place
Anoka, MN. 55303--.6234
Telephone 1-800-238-3600
Facsimile 1-800-258-0255
Qty.
1
1
2
2
2
CAUTION: Disconnect the electrical power to the unit before proceeding.
1. Remove the lower front panel from the cabinet.
2. Remove the two screws/nuts from the cup depressor lever retainer and discard the retainer.
3. Remove the existing cup depressor lever from the panel by lifting up and pulling forward. Discard lever.
4. Install new self-serve lever on panel as shown.
5. Re-Install lower front panel.
6. Connect electrical power to unit and check for proper operation of dispenser.
BEVERAGE
PANEL
4
3
5
2
Rev A, 2/5/96 Page 1 of 2
1
P/N 92325
THERE IS A COPY OF A LETTER FROM NSF IS TO BE
ATTACHED TO THIS INSTRUCTION AT THE FACTORY.
THIS SHEET IS TO BE THROWN AWAY AFTER NSF
LETTER IS ATTACHED
THIS NOTE IS NOT TO BE PRINTED -- IT IS FOR
INFORMATION ONLY.
See Frank Brill at Remcor or Al Campbell if there are questions.
Orig Date