Cornelius P/N 629088733 Installation instructions

IDC Icemaker Adaptor Kit Installation Instructions

INSTALLATION INSTRUCTIONS

IDC I

CEMAKER

A

DAPTOR

K

IT FOR

P/N 629088733

1.

Place ice slide into ice drop opening in bin (see FIGURE 2).

2.

Place bar into first set of pockets inside the ice bin.

3.

Place Icemaker Adaptor Kit on top of unit.

4.

Place icemaker on top of kit. DO NOT slide icemaker into position on the lid.

5.

Apply continuous bead of NSF international (NSF) listed silastic sealant (Dow 732 or equivalent), supplied in kit, to seal the icemaker to the top of the adapter kit. All excess sealant must be wiped away immediately.

6.

Drill 9/64” diameter holes, using one of the two supplied brackets as a template, into the rear of the icemaker and the rear of the icemaker adapter kit. USE EXTREME CARE NOT TO

DRILL INTO ANY ICEMAKER

COMPONENTS!!! Secure the icemaker to the adapter using the screws and brackets provided.

7.

For optimal performance, do not fill ice bin more than 2/3 capacity (maximum fill is 4” below top of bin). Applies to IDC

255 models only.

FIGURE 1

Ice Slide

Icemaker

Adaptor

Kit

Bar

Revision Date: May 4, 2006

© 2006, IMI Cornelius Inc.

FIGURE 2. Ice Slide Assembly

www.cornelius.com

- 1 -

Revision: A

Publication Number: 629088733INS