Craftsman 315.11099 Operator's Manual

•
ICRRFTSMRN'I
18.0 Volt
C. R DLES_S.WORKLIGHT
DO NOT STORE YOUR WORKLIGHT
IN A
DAMP OR WET LOCATION. ALSO, DO NOT
STORE IN LOCATIONS WHERE THE TEMPERATURE MAY REACH OR EXCEED 120°F.
•
Part No. 975815. -003
Use only with Craftsman battery pack
and charger (both sold separately)
Extra bulb included
For example, outside sheds, vehicles, or metal
buildings in the summer.
DO NOT PERMIT CHILDREN TO USE
WORKLIGHT UNSUPERVISED. It is not a toy.
The temperature of the bulb can become hot
after being on for an extended period of time.
This hot temperature may cause burn injury if
touched.
KEEP WORK AREA CLEAN. Cluttered areas
and benches invite accidents.
AVOID DANGEROUS
ENVIRONMENT.
KEEP LIGHT DRY, CLEAN, AND FREE FROM
OIL AND GREASE. Always use a clean cloth
when cleaning. Never use brake fluids, gasoline,
petroleum-based products or any strong solvent
to clean your light.
STAY ALERT. Watch what you are doing and
use common sense. Do not rush.
CHECK DAMAGED PARTS. Before further use
of this light, a part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. A part
that is damaged should be properly repaired or
replaced.
IMPORTANT
TOOLS
_1= CAUTION:
Read
Operating Instructions t:
product.
Safety Rules and
READ ALL INSTRUCTIONS
•
•
•
DO NOT DISASSEMBLE
•
DO NOT PLACE WORKLIGHT OR BATTERY
PACK NEAR FIRE OR HEAT. They may explode. Also, DO NOT dispose of a worn out
battery pack by incinerating.
FOR BA'I-I'ERY
Your battery tool should be charged in a location
where the temperature is more than 50°F but
less than IO0°F.
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with
soap and water, then neutralize with lemon juice
or vinegar. If liquid gets in your eyes, flush them
with clean water for at least 10 minutes, then
seek immediate medical attention.
KNOW YOUR WORKLIGHT. Read owner's
manual carefully. Learn its applications and
limitations as well as the specific potential
hazards related to this light.
USE ONLY BATTERY PACK PART NUMBER
975284-001 WITH YOUR WORKLIGHT. Any
attempt to use another battery pack will cause
damage to your light and could possibly explode,
cause a fire, or personal injury.
REMOVE BATTERY PACK FROM
WORKLIGHT BEFORE REPLACING BULB OR
PERFORMING ANY ROUTINE MAINTENANCE
OR CLEANING.
RULES
USE ONLY THE CHARGER RECOMMENDED
FOR USE WITH YOUR WORKLIGHT. Do not
substitute any other charger. Use of another
charger could cause batteries to explode causing
possible serious injury.
•
•
SAFETY
•
WHEN SERVICING USE ONLY IDENTICAL
CRAFTSMAN REPLACEMENT PARTS.
IMPORTANT
CHARGER
SAFETY
INSTRUCTIONS
FOR
•
Before using battery charger, read all instructions
and cautionary markings in this manual, on
battery charger, and product using battery charger.
,_,
WARNING:
To reduce the risk of injury, charge
only nickel-cadmium type rechargeable batteries.
Other types of batteries may burst causing
personal injury and damage.
YOUR LIGHT.
RULES
FOR SAFE OPERATION
(Continued)
•
Do not expose to rain or snow.
•
•
To reduce the risk of damage to charger body
and cord, pull by charger body rather than cord
when disconnecting charger.
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged, have
replaced immediately by a qualified serviceman.
•
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in
any way; take it to a qualified serviceman.
An extension cord should not be used unless
absolutely necessary. Use of improper
extension cord could result in a risk of fire and
electric shock. If extension cord must be used,
make sure:
a.
b.
c.
That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
That extension cord is properly wired and in
good electrical condition; and
That wire size is large enough for AC ampere
rating of charger as specified below:
Cord Length (Feet) 25ft. 50ft.
100ft.
Cord Size (AWG)
16
16
16
Note: AWG = American Wire Gage
CHARGING
YOUR
•
Do not use charger outdoors.
Make sure power supply is normal house
voltage, 120 volts, 68 hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charger then press down on
battery pack to be sure contacts on battery pack
engage properly with charger contacts•
•
Red light should turn on.
•
When battery pack is fully charged, the red light
will turn off and the green light will turn on.
BATTERY
charger from power supply when not in
Review them
frequently and use them to instruct others who
may use this light. If you loan someone this light,
loan them these instructions also.
•
Insert battery pack, making sure latches on each
side of battery pack snap in place and battery
pack is secure in light before use.
•_
CAUTION:
When placing battery pack in your
light, be sure raised rib on battery pack aligns
with groove inside light handle and latches snap
in place properly. Improper assembly of battery
pack can cause damage to internal components.
•
To remove battery pack, locate latches on end of
battery pack and depress to release battery pack
from your light.
PACK:
•
Disconnect
use,
SAVE THESE INSTRUCTIONS.
14
Charge battery pack only with the charger recommended•
TO INSTALL/REMOVE
To reduce the risk of electric shock, unplug
charger from outlet before attempting any
maintenance or cleaning. Turning off controls will
not reduce this risk.
150ft.
WORKLIGHT
TO CHARGE BATrERY
•
•
The battery pack and charger are not included with
this worklight. They are both sold separately• If you
decide to purchase a battery pack and charger, use
battery pack part number 975284-001 and charger
part number 975283-001.
•
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of
electric shock or fire.
PACK
See Figure 1.
•
•
Use 18.0 volt battery pack part number 975284-001
only.
BATTERY
Begin with a fully charged battery pack.
Note: After normal usage, the battery pack
requires 1 hour of recharge time.
•
Orient battery pack so that raised rib on battery
pack aligns with groove inside worklight. Battery
pack is designed to fit only one way in light
handle•
DEPRESSLATCHESTO
RELEASEBATTERYPACK
2
Fig. 1
BULB
SWITCH
REPLACEMENT
See Figure 2.
See Figure 3.
To turn your light on and off, depress switch trigger.
When purchasing replacement xenon bulb, request
recommended part number 981258-001,
SWITCH
TRIGGER
TO REPLACE BULB:
•
Remove battery pack from workiight.
•
Remove the two screws securing lens cover, then
remove cover.
•
Remove old bulb from spring.
•
Position new xenon bulb in spring.
•
Replace lens cover and screws.
•
Replace battery pack.
Note: For your convenience, a bulb storage area with
extra bulb has been provided. It is located behind the
lens cover. See Figure 3.
SCREWS
MULTI-POSITION
HEAD
BULB
Fig. 2
MULTI-POSITION
HEAD
See Figure 2.
Your worklight has the feature of a multi-position head
that has positive stop clicks at each position. Rotate
head to the desired position as shown in the arrows in
figure 2.
SAFETY
RULES
WARNING:
Do not operate flashlight or charger
near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes.
WARNING:
use:
BULB
STORAGE
AREA
FOR WORKUGHTS
Lens and bulb become hot during
• During or immediately after use, don't lay
worklight flat on lens surface.
• Handle worklight with care around any
flammable surface.
• If bulb has been lit, let worklight cool for
several minutes before changing bulb.
LENSCOVER
Fig. 3
To preserve natural resources, please
recycle or dispose of properly.
This product contains nickelcadmium batteries. Local, state or
federal laws may prohibit disposal of
nickel-cadmium batteries in ordinary
trash.
Consult your local waste authority for information
regarding available recycling and/or disposal options.
• Do not use or permit use of worklight in bed
or sleeping bags. A burn injury could result.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
USA
972000-671
5-99
For replacement parts information and ordering, call
this toll free number:
1-eo0-366-PART (1-800-366-7278)