Electrolux EX401ISB Installation instructions


Add to my manuals
2 Pages

advertisement

Electrolux EX401ISB Installation instructions | Manualzz

IMPORTANT

This is a guide of product dimensions only.

For complete installation instructions, refer to the manual provided with product.

installation guide

electrolux E:Line built-in dishwasher

Model: EX401ISB dishwasher dimensions and pre-installation instructions

596mm

550mm

600mm

Note: Rear leg adjustment via screw at front

Loop drain hose and locate

10mm beneath benchtop

Waste

Cold water supply

Inlet hose supplied

240V switched power outlet Drain hose supplied

Notes:

• If the floor is not level, the levelling legs should be adjusted to fit

• The dishwasher must be fixed to the cabinets with the screws provided

• The entire plastic membrane from the sink trap to be removed before fitting and securing the drain hose

• Cold water connection is recommended

• Water flow rate10L/minute min.

• Water temperature 65° max.

• Water pressure cold, 50-800kPa

• Water pressure hot, 50-800kPa

Note: Hole at bottom of spigot on sink drain must be drilled out completely. Position of spignot from base of dishwasher floor must be 300mm minimum. Maximum height of drain hose from floor must be 1000mm.

Notes:

• Ensure that hoses are not crushed or kinked under or behind the dishwasher.

• After connecting hose to the tap, turn the tap on and check to ensure that there are no leaks.

All measurements in millimetres.

Page 1 of 2

Current as at Jul 2007.

© 2006 Electrolux Home Products Pty Ltd. EDIMDWEX401ISB

IMPORTANT

This is a guide of product dimensions only.

For complete installation instructions, refer to the manual provided with product.

installation guide

electrolux E:Line built-in dishwasher

Model: EX401ISB fitting door panel

step 1 step 2

Thickness:

16mm - 26mm

595mm min. 2kg max. 10kg

Note: Refer to instructions and pattern supplied with dishwasher for hole locations and dimensions height of door determined by cabinet and kickboard height step 3 step 4

Note: Ensure that the dishwasher is fixed to cabinet step 5

All measurements in millimetres.

Page 2 of 2

Current as at Jul 2007.

© 2006 Electrolux Home Products Pty Ltd. EDIMDWEX401ISB

Note: Ensure that there is clearance between door panel and kickboard, reduce height of kickboard if necessary.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement