Emerson CK7330 Specification Sheet

SETTING THE TIME
CK7330
R
1.) Press and hold the TIME button together with the HOUR and MINUTE buttons to
adjust the time display. If the PM indicator is 'on', the time displayed is PM.
2.) Release all buttons when the correct time is displayed. The clock begins to run.
Digital Alarm Clock Radio
LISTENING TO THE RADIO
TOP VIEW
1.) Set the Function selector to the 'ON' position.
4
3
5
2
1
6
2.) Set the BAND SELECTOR switch to the AM or FM position.
3.) Rotate the TUNING knob to select the desired station.
4.) Rotate the VOLUME knob to adjust the volume level.
5.) When finished listening set the Function selector to the 'OFF' position.
For Better Reception
FM - Fully extend the AC power cord and adjust its direction and position.
AM - Rotate the entire unit until the internal AM antenna finds the strongest signal.
FRONT VIEW
SETTING THE ALARM TIME AND WAKE UP MODE
12
11
10
13
14
15
16
9
1.) Press and hold the ALARM button together with the HOUR and MINUTE button to
adjust the Wake-up Time display. If the PM indicator is 'On' the Wake-up time
displayed is PM.
2.) When the desired Wake-up Time appears, release all buttons.
3.) To wake to the buzzer set the Function selector to the 'BUZZER' position. The
ALARM indicator comes 'On'.
4.) To wake to Radio follow steps 1 - 4 in LISTENING TO THE RADIO above and then
set the Function selector to the 'AUTO' position. The ALARM indicator comes
'On'.
8
7
17
STOPPING THE ALARM
The alarm will continue for 1 hour and 59 minutes.
a.) Press SNOOZE button to stop the alarm for 9 minutes, the alarm turns 'On' again.
b.) Press the ALARM button to stop the alarm for 24 hours. It will turn 'On' again at the
same time on the following day.
LOCATION OF CONTROLS AND INDICATORS
1.)
2.)
3.)
4.)
5.)
6.)
7.)
8.)
9.)
10.)
11.)
12.)
13.)
14.)
15.)
16.)
17.)
HOUR Button.
ALARM Set/Reset Button.
SNOOZE Button.
TIME Button.
SLEEP Button.
MINUTE Button.
Speaker.
VOLUME Control.
Back-Up Battery Compartment.
(Back Cabinet)
Function Selector Switch.
(BUZZER/AUTO/ON/OFF)
ALARM “On” Indicator.
PM Indicator.
Clock Display.
BAND SELECTOR (FM/AM).
Dial Pointer.
AC Power Cord.
TUNING Control.
c.) Set the Function selector to the 'OFF' position to shut off the alarm completely.
The ALARM indicator goes 'Off'.
SLEEP TO MUSIC
Set the BUZZER/AUTO/ON/OFF switch to OFF position when you sleep to music, and
to AUTO position when you sleep to music and wake up next morning.
1.) Press the SLEEP button. The display shows "59" and the radio begins to play.
Select the desired band, station, and volume level.
2.) To increase the Sleep time by 1 hour, press the SLEEP and HOUR buttons together.
3.) To decrease the Sleep time, press the SLEEP and MINUTE buttons together. The
display begins counting down. Release the buttons when the display shows the
desired Sleep time.
4.) When the Sleep Timer counts down to "00" the radio shuts off automatically. To
shut the radio off before the Sleep Timer reaches "00" press the SNOOZE button
at any time.
CAUTION
C AU T I O N
RISK OF ELECTRIC SHOCK
POWER SUPPLY
DO NOT OPEN
AC power : 120V 60 Hz AC.
DC power : 9V battery type 006P (not provided) for clock back-up system only.
An alkaline type battery is recommended. For optimum performance,
this battery should be replaced every 6 months.
1.) Insert the AC power cord into a convenient standard AC wall outlet.
2.) Connect the 9V battery inside the compartment at the rear of the unit.
BACK-UP SYSTEM : Ensures that the unit will continue to operate as
normal during an AC power disruption (in order to preserve the battery life
the display will not light). All clock settings will be kept in the memory,
however, the clock time may require adjustment for exact accuracy. If this
battery is not installed, the display
to reset the time and alarm settings.
blinks to indicate that you have
The lightening flash with arrowhead symbol within the triangle is a
warning sign alerting the user of "dangerous voltage" inside the unit.
!
The exclamation point within the triangle is a warning sign
alerting the user of important instructions accompanying the
product.
WARNING
• To reduce the risk of fire or electric shock, do not expose this appliance to rain or
moisture.
IMPORTANT
• Do not throw batteries in fire!
• The apparatus shall not be exposed to dripping or splashing.
Visit our web site at www.emersonradio.com
CCK7330_040604.p65
1
ATTENTION : To reduce the risk of electric
shock, do not remove the cover. There are no
user serviceable parts inside the unit. Refer all
servicing to qualified personnel.
6/4/2004, 11:15
IMPORTANT NOTES
This radio is designed to operate on normal 120V 60Hz AC power only. Do not attempt to operate the
radio on any other power source. You could cause damage to the radio that is not covered by your
warranty.
This radio should be connected to an AC outlet that is always ‘live’. Do not connect it to an outlet that is
controlled by a wall switch. When the power to the radio is interrupted, the battery back up system takes
over to maintain the time and alarm settings. To maximize the life of the back up battery, keep the radio
connected to a ‘live’AC outlet at all times.
This radio uses a polarized AC plug which has one blade wider than the other. This plug will only fit into
a polarized AC outlet. This is a safety feature. If the plug will not fit, you may have an older non-polarized
AC outlet. Do not defeat the safety feature by trying to file the wider blade, or replacing the plug. Contact
an electrician to replace your outdated outlet.
AC Outlet
AC Plug
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
LIMITED WARRANTY
Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship, under normal use and conditions, for a period of ninety
(90) days from the date of original purchase in the U.S. With your dated proof of purchase, we will provide repair service at no charge for labor and parts at an authorized
Depot Repair Facility, or replace the product in our discretion. For repair or replacement, pack your unit in a padded box, enclose your check or money order payable to
Emerson Radio Corp. in the amount of $5.00 (not required by California residents) to cover shipping and handling costs, and enclose a copy of your proof of purchase. Send
your unit to:
Emerson Radio Corp.
1901 Diplomat Drive,
Farmers Branch, TX 75234.
This warranty does not cover damage from negligence, misuse, abuse, accident, failure to follow operating instructions, commercial use, rental, repairs by an unauthorized
facility, or products purchased, used, serviced or damaged outside of the United States.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
AU898H
SERVICE
TO FIND THE LOCATION AND PHONE NUMBER
OF Y OUR NEA RES T SERVI CE CE NT ER
PERMITTED TO PERFORM WARRANTY...
CALL TOLL FREE: 1-800-695-0098
FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE
PLEASE CALL:
1-800-898-9020
FOR CUSTOMER SERVICE, PLEASE WRITE TO:
Emerson Radio Corp.
Consumer Affairs Dept.
1901 Diplomat Drive,
Farmers Branch, TX 75234.
EMERSON
Part No. : 16-2917
404-02
CK7330_040604.p65
Printed in China
2
6/4/2004, 11:15