Emerson Fisher 4320 Instruction Manual

Instruction Manual Supplement
4310/4320 Wireless Position Monitor
D103856X012
April 2014
Hot Swap Procedure
Supplement to:
• TopWorx™ 4310 Wireless Position Monitor with On/Off
Control Option Instruction Manual (D103622X012)
• Fisher® 4320 Wireless Position Monitor with On/Off
Control Option Instruction Manual (D103621X012)
This procedure is used to 'swap out' a depleted power module with a new power module without having to remove
power from the device. It requires two test leads with banana plug connectors and micro-plunger clips and a new
power module. This allows the device to maintain operation and avoids disrupting the wireless network.
Note
A Hot Swap parts kit is required for this procedure. Contact your Emerson Process Management sales office for kit information.
WARNING
This procedure can only be performed when the position monitor is located in a non-hazardous location. Performing the
Hot Swap procedure in a hazardous area could result in personal injury or property damage.
Refer to figure 1.
1. Attach the banana plug connector end of the test leads to the new power module, taking care to prevent the wires
from shorting.
2. Connect the clips to to the WP2/WP3 Backup Power Terminals on the main board.
3. Loosen the four self tapping screws (see figure 2) and remove the depleted power module.
4. Position the new power module over the connections and insert on to the main board. The banana plug connector
end of the leads will come loose from the new power module.
5. Remove the clips from the WP2/WP3 Backup Power Terminals.
6. Tighten the four self tapping screws to a torque of 0.282 N•m (2.5 lbf•in) to ensure that the power module is
secured properly.
7. Close the cover and tighten the instrument cover screws to a torque of 5.6 to 6.7 N•m (50 to 60 lbf•in).
www.Fisher.com
Instruction Manual Supplement
4310/4320 Wireless Position Monitor
D103856X012
April 2014
Figure 1. Hot Swap
ATTACH CLIPS TO
WP2/WP3 BACKUP
POWER TERMINALS
TEST LEADS WITH
BANANA PLUG
CONNECTORS AND
MICRO-PLUNGER CLIPS
ATTACH BANANA
PLUG CONNECTORS
TO NEW POWER
MODULE ASSEMBLY
X0558
Figure 2. Wireless Position Monitor with Battery Sourced Power Modules
SELF TAPPING SCREWS (4)
COVER SCREWS
X0552
Neither Emerson, Emerson Process Management, nor any of their affiliated entities assumes responsibility for the selection, use or maintenance
of any product. Responsibility for proper selection, use, and maintenance of any product remains solely with the purchaser and end user.
Fisher and TopWorx are marks owned by one of the companies in the Emerson Process Management business unit of Emerson Electric Co. Emerson Process
Management, Emerson, and the Emerson logo are trademarks and service marks of Emerson Electric Co. All other marks are the property of their respective
owners.
The contents of this publication are presented for informational purposes only, and while every effort has been made to ensure their accuracy, they are not
to be construed as warranties or guarantees, express or implied, regarding the products or services described herein or their use or applicability. All sales are
governed by our terms and conditions, which are available upon request. We reserve the right to modify or improve the designs or specifications of such
products at any time without notice.
Emerson Process Management
Marshalltown, Iowa 50158 USA
Sorocaba, 18087 Brazil
Chatham, Kent ME4 4QZ UK
Dubai, United Arab Emirates
Singapore 128461 Singapore
www.Fisher.com
2E 2014 Fisher Controls International LLC. All rights reserved.