Ultrasonic Vapor Degreaser
Model B252R Portable Ultrasonic
The small but powerful Branson
B252R Vapor Degreaser
integrates state-of-the-art
controls with maintenance
practicality in an ultrasonic
vapor degreaser.
The Branson B252R Ultrasonic Vapor
Degreaser is one of a series of environmentally sound, cost effective precision
degreasers. This small but powerful
unit integrates state-of-the-art controls
with maintenance practicality in an
ultrasonic vapor degreaser. It incorporates all of the important environmental and safety features typically found
in larger units. All controls are clustered
on a compact front-mounted digital
control panel. The B252R features an
offset boiling chamber to reducing the
solvent/air interface reducing solvent
emissions and footprint. It is ideal for
use with most solvents including
HCFC, HFC, HFE, n-propyl bromide,
AK-225, and more. With a 4.8 gallon
solvent capacity, the compact B252R
is ideal for use at individual production
work stations or as a tool to develop
processes for larger equipment.
The B252R is designed to comply with
EPA environmental regulations on
solvent emissions, an important environmental and economic consideration.
Some of these features also facilitate
OSHA compliance. The unit includes,
as standard, a number of engineered
improvements designed specifically to
minimize solvent losses. The following
list details some of these more important features:
• F reeboard ratio of 100% to minimize
diffusion losses due to drafts
• Peripheral refrigerated condensing
coil to efficiently condense solvent
vapors minimizing emissions
aptured sliding cover to eliminate
drafts and help seal the unit during
periods of inactivity
ffset boiling chamber to reduce
solvent air interface to below 1 ft2
• Recirculating pump and cartridge
filter to remove particulate and extend
solvent life
In addition to the benefits associated
with keeping solvent away from the
operator, the B252R has many other
features which contribute to safety and
reliability. Key among these are:
• L ow voltage controls for operator
Ultrasonic Vapor Degreaser
• " Ready" light to assure the unit is
set to run
igh vapor level sensor to prevent
solvent boil off
• L ow solvent sensor to prevent
heater damage
oil sump temperature indicator
• E arly warning contamination
indicator to signal the need for
solvent replacement
All maintenance procedures can
be performed from the front or top
of the unit. All services also enter
conveniently from the front.
Specifications – Model B252R
Total solvent capacity: 4.8 gallon
Boil tank heat:
1200 Watts
Distillation rate based on HFC/HFE: 5.5 gph
Load capacity (steel): 80 lbs./hr.
Cooling: 1/2” HP compressor
Power requirements: 208/230V, 60 Hz, 1 ph, 16 amps
DIMENSIONS Ultrasonic tank: 8” x 10” x 6”D
Vapor zone: 10.5” x 12.5” x 6”D
Overall: with automation: 22.4” x 26.2” x 41.7”H
22.4" x 34.6" x 74"H
4 Volt controls for safety
igital temperature readouts
0 kHz industrial ultrasonics
04 Stainless steel construction
• F ull peripheral cooling coil
ne year warranty
esiccant dryer kit for azeotropic
tainless steel mesh baskets
Branson Ultrasonics Corp.
41 Eagle Road
Danbury, CT 06813-1961
T: 800-732-9262
F: 203- 796-2250
Branson Ultraschall
Niederlassung der Emerson
Technologies GmbH & Co. OHG
Waldstrasse 53-55
63128 Dietzenbach, Germany
T: +49-6074-497-0
F: +49-6074-497-199
Branson Ultrasonics (Shanghai) Co., Ltd.
758 Rong Le Dong Road
Song Jiang, Shanghai, PRC, 201613
T: 86-21-3781-0588
F: 86-21-5774-5100
Model B252R © Branson Ultrasonics
Corporation 2013
The Emerson logo is a trademark
and service mark of Emerson
Electric Co. Revised and printed
in the U.S.A. 5/13
ertical lift mechanism with
power cover