Fisher & Paykel DD24DTI7 Quick Start Guide

Add to my manuals
2 Pages

advertisement

Fisher & Paykel DD24DTI7 Quick Start Guide | Manualzz
Selecting a wash program
QUICK START GUIDE
DishDrawerTM dishwasher (Integrated)
Wash program indicators
These show which program is selected.
NZ AU US CA
Keep this document handy for easy reference.
For detailed information on the features of your dishwasher, see your ‘User guide’.
Before using your dishwasher, make sure you read the full ‘User guide’, with special attention to the ‘Safety and warnings’ section.
For contact information or if you require service, assistance or replacement parts, see the end of this document or your ‘Service & warranty’ booklet.
Your model
DD60DI7
DD24D(H)(T)I7
Note: each drawer in
double models has its own
controls and can run
independently of the
other drawer.
DD60S(T)I7
DD24S(H)(T)I7
Wash
program
selector
STANDARD PROGRAMS - designed to clean and dry your dishes
Press to
scroll
through the
wash
programs.
DD90STI2
DD36STI2
HEAVY
NORMAL
FAST
DELICATE
RINSE
ECO indicator
Heavily soiled
pots, pans and
dishes.
Dishes that are
quite heavily
soiled or food
soils that have
been left to dry
overnight
Lightly soiled
dishes.
Lightly soiled
and heat
sensitive
crockery.
Prevents
odors
and soils
drying on
dishes.
The indicator will
glow red when an
Eco program has
been selected.
ECO PROGRAMS - designed to clean your dishes energy-efficiently
Your remote control
‘Battery low’ indicator
Double models only
Your remote control
comes supplied with a
detachable mounting
bracket and self
adhesive strip. You can
choose to affix this
bracket on a nearby
surface, which should be
out of direct sunlight
and away from excessive
heat and steam. Do not
apply on wallpaper.
When this
flashes, the
battery needs to
be replaced. Use
a CR2032 battery,
ensuring the
+ symbol faces up.
(operates lower drawer)
Control button(s)
See section ‘Operating instructions’
for information.
3
Discard scraps
Scrape large food particles off
(e.g. bones, fruit stones) and
remove any foreign objects
(e.g. toothpicks, strings, paper).
Heavily soiled
everyday
dishes.
Normal soiled
dishes for
optimum
water and
energy usage.
The Energy
Guide is based
on this cycle.
Lightly soiled,
non-greasy
dishes.
Lightly soiled,
non-greasy
and heat
sensitive
crockery.
1H
10 seconds
4
4
You can operate your dishwasher in two ways:
EITHER
by using the
button
on the drawer control panel
30 seconds
Slide off remote, then
press bracket firmly to
surface for 30 seconds.
Wait 1 hour before
refitting remote.
1
2
Pause wash
You can only pause the wash with the
remote. See opposite.
Add detergent and check rinse
aid
Fill the detergent dispenser (a) with
powdered detergent and close the
dispenser door.
a
Load dishes carefully
Check spray arm(s)
Ensure there are no items
blocking the spray arm(s) from
rotating.
b
d
c
Pause the wash with the remote.
Open the drawer, then press and
hold
until you hear a
quick double beep.
Any water in the drawer will automatically
drain when you close it.
To delay the start of a wash by 1 to 12
hours:
Press and hold
. Count the beeps
as the dishwasher emits them (each
represents 1 more hour of delay) and
release the button when you have
reached the desired delay time.
The indicator of the selected wash
program will flash to show that Delay
start has been set.
The wash will start once the delay
time is over, provided the drawer is
closed.
OR
by using the
remote
control button
Cancel wash
Set Delay start
If using a tablet, place it in the
cutlery basket (d) or at the bottom
of the drawer.
Cancel Delay start
Press and hold
until you hear a quick
double beep and the indicator of the
selected wash program goes out.
Close the drawer.
Press
. The wash will start.
Start/resume wash
1
2
Pause wash
.
Press
After pausing a wash, wait for 3 beeps
before opening the drawer. Forcing it open
in mid-cycle may cause damage or injury.
Cancel wash
until you hear a quick
Press and hold
double beep.
Any water in the drawer will automatically
drain.
1
2
Do not place liquid detergent or tablets in
the detergent dispenser.
If the indicator on its plug (c) glows
bright red, refill the rinse aid
dispenser (b) with liquid rinse aid.
Make sure you then refit the rinse
aid plug back into its original
position.
Press
.
Close the drawer. The wash will start.
Start/resume wash
Important!
To help with wash performance,
arrange dishes so they are
evenly spaced and not nesting.
3
DELICATE
ECO
Operating instructions
Loading and detergent
2
FAST ECO
Peel black
liner off
Peel red liner off,
press adhesive to bracket
Press remote & bracket
to clean, dry surface
for 10 seconds
1
2
Mounting your
remote
To prevent unauthorized use, keep the remote control out of reach of children.
A single flash
indicates a
successful
signal to the
dishwasher.
Multiple flashes
indicate that
the dishwasher
cannot read
the signal. The
remote control
may be out of
range.
NORMAL
ECO
Doubles remote shown
1
Important!
Signal indicator
HEAVY ECO
You can only set Delay start on the drawer
control panel. See opposite.
Set Delay start
Cancel Delay start
Press and hold
double beep.
until you hear a quick
continued over
Closed Drawer autolock using the remote control
After the wash
The dishwasher will beep six times to indicate the end of the wash program.
You may notice the following noises at the end of the wash. These are all part of normal operation:
In double models, both drawers may be draining simultaneously.
The drying fan may continue to run after a wash program has finished for a set time. The fan assists with drying and uses
negligible amounts of energy.
For best drying results, we recommend unloading the dishes once they have cooled.
The Closed Drawer autolock feature will lock the dishwasher when the drawer is closed. To enable this feature - with the drawer closed
(and no wash program or delay start is active), press and hold
on the remote for 6 seconds until you hear a sequence of 4 beeps
together. Ignore any beeps prior to the 6 seconds. The drawer is now locked. To unlock, press
once. You will hear a sequence of 4 beeps
together. The drawer is now unlocked.
On double products, the drawers must be locked independently.
If the power to the dishwasher is disconnected, the drawer will remain locked.
Note: this feature is highly recommended if the dishwasher is to be used in motor homes.
Preference options
You can change the setting of these options to suit your preferences or circumstances. We recommend selecting the most suitable
settings before you start using your dishwasher.
Option
Dos and don’ts of loading
Rinse aid
Water softener*
Regulates the amount of rinse aid
Refer to the ‘Water softener’
dispensed. Reduce this setting if there is section of the ‘User guide’ for
What does it do? excess foam after a wash. Increase this
details.
setting if dishes are wet or streaky after
a wash.
Beeps at end of wash
Your dishwasher is factory-set to beep
six times at the end of a wash. You can
turn this setting off.
How to change the setting of an option
Sharp or pointed items must be placed
horizontally or with sharp edges/points
facing down to avoid risk of injury.
A neatly arranged load with evenly
spaced dishes helps wash performance.
1
Protruding items will stop the
internal lid of the drawer from
sealing properly, which could result
in a service call.
Overcrowding reduces wash
performance.
CHECK & OPEN
Check that there is no wash underway, then open the drawer.
2
ENTER MENU & SCROLL TO OPTION
To enter the menu: press
first with one finger, then
with another finger, hold both until one long beep sounds, then
release.
You are now in the Rinse aid option of the preference options menu.
If you want to change the Rinse aid setting, go to step 3 now.
If you want to change the setting of another option, you will need to scroll to that option first.
To scroll to the next option: press
. To know which option you’re in, keep track of the sequence of options using the table below.
When you have scrolled to the end of the sequence, it will start again with Rinse aid (after the lower tone).
Option
Rinse aid
Water softener*
Beeps at end of wash
Possible settings
1 to 5
0 to 5
On/Off
On
Example
4 indicators lit = setting is 4
3
3 indicators lit = setting is 3
Off
CHANGE SETTING
Press
to change the setting within an option. For example, to change the Rinse aid setting from 4 (factory default) to 2, you need
to press
3 times.
4
SAVE SETTING & QUIT MENU
Press and hold
Ensure there is enough space between
plates. Mix spoons, knives and forks
within the cutlery basket to prevent
them from nesting.
Ensure that water reaches all items on
the adjustable racks.
If plates and cutlery are nesting,
they are less likely to be cleaned
well.
Dishware is blocking water from
reaching items on the adjustable
racks.
until a beep sounds and the control panel reverts to showing the wash program currently selected.
*This option is disabled on models without water softener. It appears in the sequence of options but cannot be adjusted.
For more info
For detailed information on the
features of your dishwasher
see your ‘User guide’
For warranty information
see your ‘Service and warranty’ booklet
If you…
have any questions or comments
need a Fisher & Paykel authorized
technician to service your product
need replacement parts or accessories
want to register your product
see your ‘Service and warranty’ booklet or contact us
NZ
AU
USA
CA
toll-free, 24/7
toll-free, 24/7
toll-free, 24/7
toll-free, 24/7
0800 372 273
1300 650 590
1 888 936 7872
1 888 936 7872
www.fisherpaykel.co.nz
www.fisherpaykel.com.au
www.fisherpaykel.com
www.fisherpaykel.ca
590194C
09.12

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement