Fisher-Price N3570 Instruction Sheet

Please keep this instruction sheet for future reference, as it contains important information.

Requires three “C” (LR14) alkaline batteries (not included).

Adult assembly is required.

Tool required for assembly: Phillips screwdriver

(not included).

On, of f

Open close!

N3570 www.fisher-price.com

Parts

Kitchen Light

Rug

Countertop

Arch

Oven Door

Oven Base

Refrigerator

Sink Base

2 Oven Walls Oven Rack Shape Sorter Pipe

Toaster Stove Knob

Flower

Parts not shown: 2 Balls, 3 Shape Blocks

Spoon

2

Faucet

Pan

Handle

#6 x 1" (2.5 cm) Screw – 12

Shown Actual Size

Note: Tighten or loosen all screws with a Phillips screwdriver.

Do not over-tighten the screws.

CAUTION

This product contains small parts for assembly by an adult. Take extra care during unpacking and assembly.

Assembly

Oven Wall

Oven Wall

Countertop

Posts

Oven Door

• Turn the oven door upright (detail side up) and fit the pegs into the posts on each side of the oven.

Hint: The oven door is designed to fit one way. If it does not fit, turn the oven door over and try again.

1

• Fit the tabs on the oven walls into the slots in the countertop.

Oven Rack

Oven Base

2 Grooves

• Turn the oven rack upside-down (detail side down) and fit it into the groove in each oven wall.

Hint: The oven rack is designed to fit one way. If it does not fit, turn the oven rack over and try again.

3

Sink Base

4

• Fit the tabs on the oven base into the slots in the sink base.

• Insert two screws into the oven base and tighten.

Countertop Assembly

Assembly

Base Assembly

Faucet

Knob

Toaster

• Fit the base assembly onto the countertop assembly.

• Insert four screws into the base assembly and tighten.

Pipe

• Insert and "snap" the faucet, knob and toaster into the countertop, as shown.

Refrigerator

Handle

• Turn the assembly upright.

• Insert and "snap" the tabs on the pipe into the slots in the assembly, under the sink.

Shape Sorter

• Insert and "snap" the shape sorter and handle into the front of the refrigerator.

Hint: This may require extra force.

4

Assembly

Rug

Slot

Slot

Tabs

• Position the main assembly and the refrigerator as shown.

• Fit the rug grooves to the tabs on the base of the main assembly and the tab on the base of the refrigerator.

• Insert and "snap" the arch into the slot in the top of the refrigerator and the countertop.

• Insert four screws into the rug and tighten.

Arch

(Shapes Side)

"Light

Bulb"

Flower

• Insert two screws into the back of the refrigerator, near the clock.

Tighten the screws.

Assembly is now complete.

Kitchen Light

• Position the arch with the shapes facing you. Slide and "snap" the kitchen light to the arch over the "light bulb".

Hint: The kitchen light is designed to be assembled to the arch one way. If it doesn't "snap" onto the arch, turn it around and try again.

• Check to be sure the kitchen light is assembled properly by pulling it down. If you can remove it, please repeat this assembly step.

• Insert and "snap" the flower into the hole in the arch.

5

Battery Installation

Battery Compartment Door

Battery Safety Information

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable

(nickel-cadmium).

• Insert batteries as indicated inside the battery compartment.

• Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside may explode or leak.

• Never short-circuit the battery terminals.

• Use only batteries of the same or equivalent type, as recommended.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the product before charging.

• If removable, rechargeable batteries are used, they are only to be charged under adult supervision.

1.5V x 3

“C” (LR14)

• Locate the battery compartment door (burner) on the countertop.

• Loosen the screws in the battery compartment door. Remove the battery compartment door.

• Insert three “C” (LR14) alkaline batteries, as indicated inside the battery compartment.

Hint: We recommend using alkaline batteries for longer battery life.

• Replace the battery compartment door and tighten the screws.

• When lights or sounds from this toy become faint or stop, it’s time for an adult to change the batteries!

• Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).

6

Slide the mode switch to either Learning

Time, Musical fun,

Imagination or Off.

Two Sides of Learning Fun!

Turn the clock hands

Fit shape blocks into the arch

Spin the flower

Lift and lower the faucet

Adjust the volume to low, medium or high for your child's comfort.

Flip the page

Spin the fish bowl

Push the toast

Drop balls down the drain

Flip the switch to turn on the light

Crawl through the arch

Turn the dial

Fit shape blocks into the shape sorter

Spin the roller

Open and close the oven door

Learning Time

Learn A-B-C's, 1-2-3's, colors, shapes and more!

Place the pan on the burner Open and close the refrigerator door

Musical Fun

Listen to favorite tunes, fun phrases and silly sounds.

7

Imagination

Enjoy role play fun along with realistic sounds in the kitchen.

Consumer Information

FCC Statement (United States Only)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

Care

• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not immerse this toy.

• This toy has no consumer serviceable parts. Do not take this toy apart.

• Before use, thoroughly wash all parts that may contact food.

The pan and spoon are not dishwasher safe.

Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.

©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

N3570pr-0920

PRINTED IN MEXICO