FMW51BC1
External Battery Charger
2. Insert the battery pack into one of the slots in the battery
charger as shown in the following figure until the battery
pack is firmly seated in the charger.
User’s Guide
PenCentra 130 / PenCentra 200
Stylistic LT / Stylistic LT C-500
3. There are two status indicators on the battery charger,
one for each slot. The status indicators change colors to
represent different battery conditions, as noted in Table 1.
The FMW51BC1 external battery charger allows
you to charge two battery packs simultaneously.
Caution
Table 1: Status Indicator States
UL Notice: FMW51BC1 External Battery Charger
Indicator
PenCentra Users: Use this battery charger with the
FMW51BP1 battery pack only.
Condition
Power
Status
OFF
AC Adapter not connected
Green/ON
Stylistic LT Users: Use this battery charger with the
3-cell battery pack FMW29BP2 or 6-cell battery pack
FMW29BP1 only.
Battery 1/
Battery 2
Stylistic LT C-500 Users: Use this battery charger with
the 6-cell battery pack FMW43BP2 only.
AC Adapter connected
OFF
No battery installed
Green/ON
Amber
Charge complete
ON
Blink
Using the Battery Charger
0
Red
1. Connect an FPC DC power source such as AC
Adapter FMWAC4, FMWAC14, or Auto Adapter
FMWCB2 to the DC input on the battery charger.
The Power status indicator on the charger turns on
indicating that power is supplied to the charger.
ON 2
Blink
To charge your battery pack(s) in the external
battery charger:
Charging
1
1,2
Standby (Waiting to charge)
Battery pack alarm
Battery charger alarm
1
Blinks at rate of one second on, one second off.
2
If the battery charger indicates a fault condition with the
battery pack, remove the battery pack, disconnect power to
the charger, and contact your local help desk or your reseller
for further assistance.
Status
Indicators
Slide
Connector Pins
Power
1
Battery Slot 2
Battery 1
Battery Slot 1
2
DC Input
Battery 2
Rechargeable
Battery Pack
Stylistic LT, Stylistic LT C-500, PenCentra 130, and PenCentra 200 are trademarks of Fujitsu PC Corporation. © 2000 Fujitsu PC Corporation
8/00
58-0664-00B
4. When the charged battery pack is needed,
remove the battery pack from the charger.
FCC Notice
When the battery charger is not in use, disconnect
the DC power source.
Operational Considerations
0
Issues to consider when you use the FMW51BC1
battery charger are discussed as follows:
• You can insert up to two battery packs at a time
in the battery charger. When charging two
battery packs, you can insert or remove either
battery pack independently.
• The battery charger only charges one battery
pack at a time. When two battery packs are
inserted in the charger, the battery pack installed
first is charged first.
• The battery charger will indicate a full charge
level and will not begin charging the battery pack
if the battery pack charge level is 90% or higher
when the battery pack is initially inserted in the
charger. This prevents the battery pack from
being overcharged.
• When you remove the battery pack from your
pen tablet, always insert a charged battery pack
in the pen tablet to replace the one that you
removed, or apply DC power.
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
• The FMW51BP1, FMW29BP1, FMW29BP2, and
FMW43BP2 battery packs use lithium ion battery
cells which have no “memory effect.”You do not
need to discharge or “condition” the battery pack
before charging.
Battery Pack Charge Time
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try and correct the
interference by one or more of the following
measures:
Changes or modifications not expressly
approved by Fujitsu Personal Systems, Inc.,
could void the user’s authority to operate the
equipment.
0
The approximate maximum amount of time needed
to charge a fully discharged battery pack to the 90%
level is shown in the following table. Note that when
two battery packs are installed in the charger, they
are charged sequentially (starting with the battery
pack that is installed first).
Battery Pack
3-cell
2 of 2
Approximate
Charge Time
FMW51BP1
<2 hours
FMW29BP2
<2 hours
6-cell
FMW29BP1
<3.5 hours
6-cell
FMW43BP2
<3.5 hours
58-0664-00B