Fujitsu Stylistic Q572 Getting Started Guide

Getting Started
Get Started with your
Fujitsu STYLISTIC® Q572 Tablet PC
This guide will lead you through the start-up process for your new LIFEBOOK tablet and will also provide some
valuable tips. To learn about all the exciting features that your new LIFEBOOK tablet has to offer, please see the
User’s Guide that can be accessed after completing the start-up procedure.
ENGLISH
This convenient guide will lead you through the start-up
process and will also offer some valuable tips.
What’s in the Box
Check to see that all of the following items are in the box:
■■ STYLISTIC Hybrid Tablet
■■ Lithium Polymer battery, pre-installed
■■ AC adapter with power cord
Depending upon your configuration, the following
items may also be shipped with your tablet:
■■ Microsoft Product Identifier (bi-fold paper contains
Microsoft Office product key for activation
Controls, Connectors, and
Access Points
Display
Front Web Camera
Speaker
Web Camera Access LED
Illumination Sensor
Docking Cradle Connector
Windows Button
Docking Cradle Guide Pin
Speaker
left PANEL
RIGHT PANEL
Built-in Microphone
DC-In Jack
Air Vents
USB 2.0 Connector
USB 2.0
Connector
Headphone Jack
HDMI Connector
Built-in Microphone
Volume Up
Button
Power/
Power Indicator Pen Tether
Attachment
Suspend/
Charge Indicator
Point
Resume Switch
Wireless
On/Off Switch
Volume Down
Button
Rotation Lock
Button
Pen Attachment
Slot
bottom PANEL
Battery Lock Latch
SmartCard Slot
Rear Web Camera
SD Card Slot
Battery Release Latch
Removable Battery
Fingerprint Sensor
Page 2 of 5
Pen Tether Attachment Point
Initial Start Up
Pen Cap
AAAA-battery
1. Install the Pen Battery
■■ Remove the cap from the end of the pen and insert a AAAA-battery positive end first. Reinstall the
pen cap.
2. Attach the Pen Tether
■■ Take the smaller loop on the pen tether and insert it about half way into the slot in the pen cap.
Thread the tether through the end of the loop extending through the slot. Now take
the larger loop on the tether and insert in the same manner through the attachment point on
the right side of your tablet. Thread the pen through the end of the loop extending through the
attachment point.
Pen Barrel
3. Connect AC Power
■■ Plug the power cord into the AC adapter.
■■ Plug the AC adapter into your STYLISTIC Tablet PC.
■■ Connect the power cord to an electrical outlet.
4. Booting the System
DC Power Jack
AC Adapter
■■ We strongly recommend that you do not attach any external devices until you have gone
through the initial power on sequence.
■■ Slide and release the Power/Suspend Resume switch.
■■ Your tablet is now on and the battery is being charged.
■■ When you turn on your tablet for the first time, it will display a Fujitsu logo on the screen.
If you do nothing the system will load the operating system, and then the Windows
Welcome will begin.
5. Starting Windows® for the First Time
Wireless
Device
Switch
Power/Suspend/
Resume Switch
■■ After you boot up the system the first time and follow the instructions on the screen, you will
eventually come to the Welcome window. After the Welcome window appears, the screen will black
out for up to several minutes. This is normal. DO NOT ATTEMPT TO POWER DOWN THE SYSTEM
AT THIS POINT. While the screen is blacked out, your system configuration is being set up and the
necessary files are being installed.
■■ During the course of the first start up, you will need to read and accept the End User License
Agreements (EULAs) for Microsoft and Fujitsu.
If you reject the terms of the license agreement you will be asked to review the license agreement for
information on returning Windows® or to shut down your tablet.
You cannot use your tablet. until you have accepted the license agreement. If you stop the process your tablet. will
return to the beginning of the Windows® Welcome Process, even if you shut your tablet. down and start it up again.
your
with ook
teb
arted No
2
t St
Ge® AH53
K
OO
EB
LIF
6. Connect to the Internet or Network
■■ Move the Wireless On/Off switch to on. After you have configured your computer, you can connect
to an active network by clicking on the Wireless Network icon in the system tray
■■ Register your STYLISTIC Q702 with Fujitsu Service and Support via our website (http://solutions.us.fujitsu.com/www/content/support/). This helps
us to better serve you.
7. Activate Additional Utilities, Applications, & Drivers
■■ You can launch desktop icon “Fujitsu Bonus Apps” to see if there are any additional applications available for the system. Bonus Apps contains
optional applications. You can select individual or all software that is available. BonusApps will automatically install for you.
8. Calibrating the Display
In order to ensure accurate tracking between the stylus and cursor, you must run the Calibration Utility before you use the system for the first
time, or after you change the display resolution.
To run the calibration utility:
■■ Go to Start -> Control Panel.
■■ Double-click the Tablet Settings icon and select the Display tab
■■ Click the [Calibrate] button, then select whether you want to calibrate pen input or touch input.
■■ Adjust the display of your tablet to a comfortable angle and find the (+) symbol in the upper-left corner of the display.
DO NOT USE EXCESSIVE FORCE WHEN TAPPING ON THE SCREEN DURING CALIBRATION. USE OF EXCESSIVE FORCE COULD RESULT IN DAMAGE TO THE
LED AND/OR TOUCH PANEL
■■ Using the stylus or your finger (depending upon which type of input you are calibrating), firmly touch the screen directly on the (+) symbol. Lift the
stylus from the screen and the target will move to a different location on the screen.
■■ Repeat the previous step until you have selected all of the (+) symbols.
■■ Once you have selected all the symbols, press the [OK] button.
■■ Touch the stylus to various points on the screen to verify that the screen is correctly calibrated. If you are not satisfied with the screen’s calibration,
press the [Calibrate]) button to begin again.
9. Create backup media with MyRecovery
■■ Click on the [MyRecovery] icon to create backup recovery media discs. (You will need to use an external optical drive.)
■■ Look in the User’s Guide (Troubleshooting Your STYLISTIC Q702) for more detailed instructions.
10. User’s Guide
■■ Your electronic User’s Guide contains important detailed information about your new computer. You can access your User’s Guide by selecting its icon
from the screen desktop. (You will need to be connected to the Internet.)
Page 3 of 5
Common Indicators
Quick Tips
Status Display Panel
It takes approximately 3 hours to charge a fully discharged single battery with unit off or in
suspend mode.
Optimizing Battery Life
• Set power management setting for best battery life.
• Adjust display brightness levels to lowest comfortable setting.
• Utilize Suspend mode when not using your tablet.
• Read the Power Management section in your User’s Guide for additional features.
Heat damage to your Lithium ion battery
• Extended exposure to heat will have a negative impact on your battery. Do not expose your
tablet to excessive heat such as leaving it in the car on a hot summer day. If you are near
an outlet and playing a graphics-intensive game, it is recommended that you remove the
battery from the unit to avoid exposing it to excessive heat.
Discharging your battery
• Full battery discharges (to unit shutdown or 0%) should be avoided. It is recommended that
batteries only be partially discharged to levels of 20-30% before recharging.
Prolonged storage
• If your tablet isn’t going to be used for a while, you should remove its Lithium ion battery. To
store a battery for long periods of time, its charge capacity should be around 40% and store
it in a cool dry place.
Purchasing a replacement battery
• Only purchase a replacement battery from Fujitsu. Ensure that you purchase a battery that
is specifically designed for your model computer. It is recommended that you purchase
a replacement battery only when the current battery has noticeably degraded; unused
batteries will still suffer degradation when stored.
The indicators are only visible when the unit is on.
Power
Indicator
Charge/DC-In
Indicator
Windows
Button
Button Name
Primary Function (Press)
Description for Rotation and Windows
Buttons
Volume Down Button
Volume Down
Volume UP Button
Volume Up
Rotation Button
Rotate Lock
When you press and hold the Rotation Button,
the autorotation feature is turned off or
turned on, depending on its previous state.
If you press the Rotation button while the
Fujitsu logo appears during system boot, the
BIOS Setup Utility will open. While you are in
the BIOS Setup utility, the Volume up button
functions as a up arrow key and volume down
button functions as a down arrow key.
Windows Button
Quick access to the
Start menu
Volume Down
Rotation
Button
Lock Button
Volume Up Button
When you press and hold the Windows
button, then slide the power button,
the CTRL+ALT+DEL screen is brought up.
Important Safety Instructions
This unit requires an AC adapter to operate. Use only UL Listed I. T .E. Adapters with an output rating of 19 VDC, with a current of 3.16A (60 W).
AC adapter output polarity:
When using your Tablet PC, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the
following:
CAUTION: HOT SURFACE: THE BOTTOM OF THIS COMPUTER CAN BECOME HOT WHEN USED FOR LONG PERIODS OF TIME. WHEN USING THIS DEVICE, TAKE CAUTION TO LIMIT
LONG TERM OR CONTINUOUS USE WHILE RESTING IT ON EXPOSED SKIN, SUCH AS THE LAP.
CAUTION: Risk of Explosion of Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions.
•- D
o not use this product near water for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool.
•- Uses only the power cord and batteries indicated in the User’s Guide for this product. Do not dispose of batteries in a fire. They may explode. Check with
local codes for possible special disposal instructions.
Save These Instructions
For Authorized Repair Technicians Only
DANGER OF EXPLOSION IF LITHIUM (CLOCK) BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE
MANUFACTURER. DISPOSE OF USED BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTION.
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH THE SAME TYPE AND RATING FUSE.
Page 4 of 5
Popular Accessories
Additional Main Lithium Polymer Battery
(For optional Keyboard docking station)
Auto/Airline Power Adapter
Additional AC Adapter
Carrying Cases
STYLISTIC Q572 Tablet PC Cradle
Have questions or need help?
• Visit our website at solutions.us.fujitsu.com
• Call us anytime at 1.800.8FUJITSU
• Email us at 8fujitsu@us.fujitsu.com
Want more information on Fujitsu products?
• Visit our website at www.shopfujitsu.com
• Call us anytime at 1.800.FUJITSU
Fujitsu Extended Service Plans available.
Visit us.fujitsu.com/computers
to purchase any of these accessories
or to get more information.
Record your tablet serial number here:
Serial #______________________
(see bottom of computer)
Fujitsu America, Inc.
1250 E. Arques Avenue
Sunnyvale, CA 94085
Fujitsu, the Fujitsu logo, and STYLISTIC are registered trademarks of Fujitsu Limited.
Microsoft and Windows are registered trademarks or trademarks of Microsoft
Corporation in the United States and/or other countries. All other trademarks
mentioned herein are the property of their respective owners. Product description
data represents Fujitsu design objectives and is provided for comparative purposes;
actual results may vary based on a variety of factors. Specifications are subject to
change without notice.
©2012 Fujitsu America, Inc. All rights reserved.
Page 5 of 5