Installation Guide
GE
Lighting Solutions
Lumination LED Luminaires
TM
GESK01 Slanted Ceiling Mount Kit
GESK02 Seismic Bracing Kit
Installation: Slanted Ceiling Mount Kit
Remove cable coupler
Squeeze gripper
to release cable
1
Remove aircraft cable from gripper by squeezing
the top. Then remove cable from cable coupler.
2
Feed aircraft cable through slanted cable coupler
and gripper.
4
Installed.
Junction box
installed into
slanted ceiling
Stud
3
Fit canopy over stud of crossbar, then screw
cable coupler onto stud. Repeat Step 1 to Step 3
on other side.
imagination at work
Installation: Seismic Bracing Kit
Bracing cables
Attach clamp
6 inches
Mount to wall or ceiling
Bracing cable
1
Attach bracing cables clamp about 6” above the
Y-cable for both ends.
3
Installed.
2
Anchor the Side Cable Exit Gated Hook (4 pieces) to
wall or ceiling.
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
1-888- 69- 43-533
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Lumination is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.
© 2012 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
IND028-073012