GE WPRE8150KWT User's Manual

Installation Instruction - Quick Reference Guide
GE imagination at work
Dele la vuelta para instrucciones en español
For the complete and detailed installation instructions as well as all safety concerns and warnings, please refer to the installation instructions manual.
1. Unpack your washer
2. Remove metal rod from
bottom right
3. Install drain hose to the
back of the washer
Styrofoam block &
owner’s manual
Fill hoses
and parts
bag
Use screwdriver
Remove rod by pulling on
yellow plastic handle
Install washers. (Washers should
be brand new. Replace them if
they are old or worn). Use pliers
to tighten 1/2 turn beyond
hand-tight
Drain
hose
Avoid a
Circles or ovals are color matched
between pictures to help show
location on product
5. Connect water supply
hoses to wall faucets
Repair!
Slip Joint
Pliers
Level
Repair!
Use clamps and screws for drain
hose installation; without them
leaks and flooding may occur
Avoid a
Repair!
Avoid a
Repair!
Meet 30” drain hose height
requirement. Less than 30”
without U clip WILL NOT allow
proper washer operation
Do not cross thread the water
hoses and do not forget to
install the washers. Flooding
may occur
Repair!
8. Installation
complete!
Congratulations! Your installation is successful and complete.
Refer to your Owner’s Manual for operation instructions.
Level
front legs
left to right
Install screen washers; without
them debris will clog the valve
and flooding will occur
Avoid a
7. Level your washer
and plug it in
Use cable tie
clip
Do not mix hot and cold water
supplies. Mixing them will
result in poor wash perfomance
Avoid a
Repair!
6. Connect drain hose
to drain opening
Install screens.
(Screens
should be
brand new.
Replace
them if
they are old
or worn).
Use pliers to
tighten 1/2
turn beyond
hand-tight
Avoid a
Phillips Head
Screwdriver or 1/4"
Nut Driver
Remove metal rod. Leaving rod
in place WILL result in severe
damage to the washer
Repair!
Avoid a
Tools you will need
4. Connect water supply
hoses to back of washer
Avoid a
Repair!
Tilt washer
forward 4 to 6
inches and
then set it back
down – rear legs
will self-align
Ensure washer is properly
leveled, otherwise damage
WILL occur
Ensure that washer is powered
by 115V, 15 or 20 amp wall
receptacle
Avoid a
Repair!
Check for leaks after you turn
on the water
Download PDF
Similar pages
GE WPRE User's Manual
Sekonic SR-1800
Silex SX-3100
Philips HL7710
Ad - EX23 (1999)
Lite-On 128GB M3