Harbor Freight Tools 7 in. x 10 in. Precision Benchtop Mini Lathe Quick Start Guide

TO START
5
Q U I C K
S TART
G U IDE
7" x 10"
IMPORTANT: SEE MANUAL FOR DETAILED
INSTRUCTIONS OF THESE PROCEDURES.
PRECISION MINI LATHE
A. Follow SET-UP on Reverse.
B. Close Chuck Guard.
STOP: MAKE SURE ALL FRONT
CONTROLS ARE SET TO “OFF”
OR “0”.
C. Plug in the Lathe.
D. Move Forward-OFF-Reverse
Switch to desired direction.
E. Move Power Switch to “ON”
position.
F. Turn Variable Speed Control
Knob to desired speed.
REVERSE
I
OFF
O
FORWARD
1
0
TO STOP
6
A. Turn Variable Speed
Control Knob to “0”.
B. Move Forward-OFFReverse Switch to
“OFF” position.
C. Move Power Switch
to “OFF” position.
D. Unplug the Lathe.
REVERSE
OFF
FORWARD
I
O
1
0
Read the user manual completely before using this product. Failure to do
so can result in serious injury.
Always wear ANSI-approved eye protection before using this product
Copyright© 2012 by Harbor Freight Tools®. All rights reserved. REV: 14c
Item: 93212
SET UP
1
Unplug Lathe.
SET UP
2
Install required Jaws into Chuck.
L
N
R
3
Back Controls
Set up workpiece:
A. Secure workpiece.
B. Install cutting tool (sold separately) in Tool Post.
C. Set Automatic Feed Lever.
D. If threading, set Threading Dial. Tool Post
4
Adjust Controls before Start.
A. Set Spindle speed with H/L
Gear Shift Lever.
B. Set feed direction with Feed
Direction Selector.
STOP: MAKE SURE
ALL FRONT CONTROLS
ARE SET TO “OFF” OR “0”.
Front Controls
REVERSE
OFF
FORWARD
Automatic
Feed Lever
Threading Dial
I
O
1
0